DC821 DeWALT Impact Driver

This is a genuine Dewalt replacement part, it is sold individually. The purpose of the Detent Pin is to secure sockets to the anvil on the Impact Wrench model numbers shown below. It is held in the an...

Genuine OEM replacement part, this item is sold individually. This spring is used in various locations of the tools listed below. Over time springs will loose their tension and will need to be replace...

This is a genuine Dewalt replacement part designed for use with a variety of power tools. It is a standard hardware which has multiple applications based on your tools. This is a metal torx T-10 screw...

This is an original Craftsman replacement part sourced directly from the manufacturer. The roll pin is found in impact wrenches and multi-purpose saws from Craftsman. This metal part is used as a fa...

This is a Trigger type switch that has 2 terminals, a battery connector, a heat sink and an unattached forward/reverse lever. This genuine DeWalt replacement part is sold individually. rnrnSwitches a...

This is a standard Dewalt logo decal/label commonly used on electric drills/drivers. It is a genuine part that is supplied directly from original equipment manufacturer. If you want to keep your tool ...

Battery cap

This authentic manufacturer-sourced component is specially designed for DeWALT power tools. It is an identical replacement for a missing or a damaged hardware that was installed on a new unit. Refer t...

This is an authentic manufacturer sourced replacement anvil assembly that is specially designed for Dewalt impact wrenches. The anvil experiences a lot of pressure, it can wear down both at the tip wh...

This part has been sourced from the original manufacturer to be used with jigsaws and impact wrenches from DeWalt. The carbon brushes are used to relay electricity from the switch to the motor's armat...

This 18V battery is a genuine Dewalt replacement accessory, not generic or aftermarket. It is a high end XR (extended run-time) battery with a high amp hour rating allowing it to run longer between ch...