Models
>
ZDIS15CSSM
ZDIS15CSSM Whirlpool Ice Maker
Jump to:
Find Part by Name
Keep searches simple, eg. "belt" or "pump".
Diagrams for ZDIS15CSSM
Viewing 5 of 5Keep searches simple, eg. "belt" or "pump".
$127.54
This condenser fan motor kit is used in icemakers and freezers, the purpose is to circulate air through the condenser in the compressor area in order to keep it cool. If your fridge is making loud noi...
In Stock
Order within the next 5 hrs and your part ships today!
$20.52
This nickel-safe, unscented ice machine cleaner measures 16 fluid ounces and is used to remove mineral build-up and hard water and is compatible with several makes and models of freestanding ice machi...
In Stock
Order within the next 5 hrs and your part ships today!
$36.12
This is the replacement water tube kit for your refrigerator. This tubing is made of plastic, is 1/4 inch in diameter, and comes with 2 inserts. This tube may be longer than the original tube, and may...
In Stock
Order within the next 5 hrs and your part ships today!
$75.62
This part monitors the temperature and sends the readings to the electronic control board.
In Stock
Order within the next 5 hrs and your part ships today!
$60.72
There is approximately 10'of wire.
Note:2 kits are needed to replace both directions.
In Stock
Order within the next 5 hrs and your part ships today!
In Stock
Order within the next 5 hrs and your part ships today!
This is an ice cutter grid assembly for your ice maker. If your machine is not producing ice properly, the assembly may need replacing. You will find this part in the main unit of the ice maker. The t...
In Stock
Order within the next 5 hrs and your part ships today!
In Stock
Order within the next 5 hrs and your part ships today!
In Stock
Order within the next 5 hrs and your part ships today!
Used with freestanding ice cube makers.
In Stock
Order within the next 5 hrs and your part ships today!
In Stock
Order within the next 5 hrs and your part ships today!
In Stock
Order within the next 5 hrs and your part ships today!
Questions and Answers
We're sorry, but our Q&A experts are temporarily unavailable.
Please check back later if you still haven't found the answer you need.
Common Problems and Symptoms for ZDIS15CSSM
Viewing 11 of 11Noisy
Fixed by these parts
![Fixing](https://fixcom-g4bhetdmcgd9b7er.z01.azurefd.net/assets/PartImages/1957416_2_s.jpg)
![Fixing](https://fixcom-g4bhetdmcgd9b7er.z01.azurefd.net/assets/PartImages/11742475_1_S.jpg)
How to fix it
Light not working
Fixed by these parts
![Fixing](https://fixcom-g4bhetdmcgd9b7er.z01.azurefd.net/assets/PartImages/11738900_1_s.jpg)
How to fix it
Leaking
Fixed by these parts
![Fixing](https://fixcom-g4bhetdmcgd9b7er.z01.azurefd.net/assets/PartImages/11730901_1_S.jpg)
![Fixing](https://fixcom-g4bhetdmcgd9b7er.z01.azurefd.net/assets/PartImages/11742760_1_s.jpg)
![Fixing](https://fixcom-g4bhetdmcgd9b7er.z01.azurefd.net/assets/PartImages/1957416_2_s.jpg)
How to fix it
Fridge too warm
Fixed by these parts
![Fixing](https://fixcom-g4bhetdmcgd9b7er.z01.azurefd.net/assets/PartImages/1957416_2_s.jpg)
How to fix it
Freezer section too warm
Fixed by these parts
![Fixing](https://fixcom-g4bhetdmcgd9b7er.z01.azurefd.net/assets/PartImages/1957416_2_s.jpg)
How to fix it
Ice maker not making ice
Fixed by these parts
![Fixing](https://fixcom-g4bhetdmcgd9b7er.z01.azurefd.net/assets/PartImages/11730901_1_S.jpg)
How to fix it
Will Not Start
Fixed by these parts
![Fixing](https://fixcom-g4bhetdmcgd9b7er.z01.azurefd.net/assets/PartImages/1957416_2_s.jpg)
![Fixing](https://fixcom-g4bhetdmcgd9b7er.z01.azurefd.net/assets/PartImages/11742479_1_S.jpg)
How to fix it
Fridge and Freezer are too warm
Fixed by these parts
![Fixing](https://fixcom-g4bhetdmcgd9b7er.z01.azurefd.net/assets/PartImages/1957416_2_s.jpg)
How to fix it
Fridge runs too long
Fixed by these parts
![Fixing](https://fixcom-g4bhetdmcgd9b7er.z01.azurefd.net/assets/PartImages/1957416_2_s.jpg)
How to fix it
Clicking sound
Fixed by these parts
![Fixing](https://fixcom-g4bhetdmcgd9b7er.z01.azurefd.net/assets/PartImages/1957416_2_s.jpg)
How to fix it
Not dispensing water
Fixed by these parts
![Fixing](https://fixcom-g4bhetdmcgd9b7er.z01.azurefd.net/assets/PartImages/11730901_1_S.jpg)
How to fix it
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
- Customer:
- Josue from Jacksonville, NC
- Parts Used:
- W10124096
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
- Tools:
- Screw drivers
Seven year old condenser fan was making noise when it was running.
The process to repair was very simple, I removed the back of the refrigerator to expose the motor area. I then removed three screws that held the condenser motor in place. once it was loose I detactched the electrical harness and removed the old motor. I then placed the new motor in place and secured it with the screws and reattached the
... Read more
new electrical harness that came with the new part. Once completed I reviewed it to make sure I didn't miss anything. I then replaced the cover over the motor area and enjoyed my success in repairing my own appliance with no added cost for labor, which would have been expensive I'm sure. The part purchased came with clear and consice instructions very easy to follow.
Read less
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Louis from Cheyenne, WY
- Parts Used:
- WP2217220
- Difficulty Level:
- Really Easy
- Total Repair Time:
- 30 - 60 mins
- Tools:
- Nutdriver
Lack of frequent cleaning resulted in pump failure due to buildup from hard water mineral deposists
This ice maker is really a Kitchenaid appliance.
1. Remove all ice and drain water pan by removing drain cap.
2. Disconnect waterline and unplug ice maker
3. Set icemaker on a work bench unless you like working on your knees, head down.
4. Remove flip out chute and ice scoop bracket.
5. Remove water pan ... Read more by removing thumb screws
6. Remove single 1/4" head cap screw that holds plastic cover over pump.
7. Remove discharge hose from pump. Pull clear plastic 1/8" diameter water supply line from notch in left edge of pump base.
8. Remove three cap screws holding pump. Two are visible. The third one is behind the pump and requires an 8" extension on the socket.
9. After the three screws are removed the pump drops down. The electric connection must be unplugged. Pinch the tabs on either side to release the plug.
10. Reverse procedure to install new pump. Unless you have really small hands or love being frustrated, don't bother to reinstall the third screw that is behind the pump. The pump stays in place just fine without that screw.
11. After reinstalling the icemaker, clean thoroughly by washing all inside surfaces with a strong bleach solution.
12. Run a cleaning cycle with one quart of strong bleach solution in the water tray. At the conclusion of the cleaning cycle, drain the water tray. Place unit into service. DON'T FORGET TO CLEAN REGULARLY. If the water supply is not chlorinated molds and algae will develop in recirculation hose.
1. Remove all ice and drain water pan by removing drain cap.
2. Disconnect waterline and unplug ice maker
3. Set icemaker on a work bench unless you like working on your knees, head down.
4. Remove flip out chute and ice scoop bracket.
5. Remove water pan ... Read more by removing thumb screws
6. Remove single 1/4" head cap screw that holds plastic cover over pump.
7. Remove discharge hose from pump. Pull clear plastic 1/8" diameter water supply line from notch in left edge of pump base.
8. Remove three cap screws holding pump. Two are visible. The third one is behind the pump and requires an 8" extension on the socket.
9. After the three screws are removed the pump drops down. The electric connection must be unplugged. Pinch the tabs on either side to release the plug.
10. Reverse procedure to install new pump. Unless you have really small hands or love being frustrated, don't bother to reinstall the third screw that is behind the pump. The pump stays in place just fine without that screw.
11. After reinstalling the icemaker, clean thoroughly by washing all inside surfaces with a strong bleach solution.
12. Run a cleaning cycle with one quart of strong bleach solution in the water tray. At the conclusion of the cleaning cycle, drain the water tray. Place unit into service. DON'T FORGET TO CLEAN REGULARLY. If the water supply is not chlorinated molds and algae will develop in recirculation hose.
Read less
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Randy from Hays, KS
- Parts Used:
- WP2149705
- Difficulty Level:
- Really Easy
- Total Repair Time:
- 15 - 30 mins
- Tools:
- Socket set
Broken light switch
Took all the screws out of the plastic shroud that encloses the switch .There only four that I needed to remove, were the two in front where the switches that go,they go in horizontally and two in the back with large washers on them that hold the back to the top of the box that go in vertically.The switch was a snap ( make that two snaps
... Read more
) the wiring is almost self explanatory. then it gos back to the way you took it off. OH! and don't forget to turn the light bulb all the way back in to the socket , so the light will work after you take the time to install it yourself.I had the water supply line from under the box to the water dispenser in the door and the total bill on that was one hundred thirty seven and a hand full of change.Don't be afraid to do it yourself the savings is enough on one one item to make several months payments on a new one Randy the "Handy Man'
Read less
Was this instruction helpful to you?
Thank you for voting!