Models
>
10689589701
10689589701 Kenmore Ice Maker
Jump to:
Find Part by Name
Keep searches simple, eg. "belt" or "pump".
Diagrams for 10689589701
Viewing 5 of 5Keep searches simple, eg. "belt" or "pump".
$75.62
This part monitors the temperature and sends the readings to the electronic control board.
In Stock
In Stock
In Stock
In Stock
In Stock
In Stock
In Stock
In Stock
On Order
In Stock
$50.05
Leveling leg Now includes two different sizes. Use the one for your model. If you need two legs you will need to purchase a QTY of two of this kit.
In Stock
In Stock
Questions and Answers
We're sorry, but our Q&A experts are temporarily unavailable.
Please check back later if you still haven't found the answer you need.
Common Problems and Symptoms for 10689589701
Viewing 1 of 1Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
- Customer:
- Randy from Hays, KS
- Parts Used:
- WP2149705
- Difficulty Level:
- Really Easy
- Total Repair Time:
- 15 - 30 mins
- Tools:
- Socket set
Broken light switch
Took all the screws out of the plastic shroud that encloses the switch .There only four that I needed to remove, were the two in front where the switches that go,they go in horizontally and two in the back with large washers on them that hold the back to the top of the box that go in vertically.The switch was a snap ( make that two snaps
... Read more
) the wiring is almost self explanatory. then it gos back to the way you took it off. OH! and don't forget to turn the light bulb all the way back in to the socket , so the light will work after you take the time to install it yourself.I had the water supply line from under the box to the water dispenser in the door and the total bill on that was one hundred thirty seven and a hand full of change.Don't be afraid to do it yourself the savings is enough on one one item to make several months payments on a new one Randy the "Handy Man'
Read less
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Ray from Terry, MS
- Parts Used:
- WPW10503764
- Difficulty Level:
- Very Easy
- Total Repair Time:
- 15 - 30 mins
- Tools:
- Nutdriver
Ice maker overfilling with ice and would not stop production when full.
Very easy to replace. Down load the Manual online for a completely operating manual. Thermistor can be tested with an Ohm Meter. Proper values are listed in operating manual.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Dennis from Houston, TX
- Parts Used:
- WPW10503764
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
- Tools:
- Screw drivers, Wrench set
IceMaker was overflowing so the suspicion was the Ice level sensor was working
The most difficult part of this order was identifying the part. The manual and picture for this model icemaker called the part a Ice level Sensor. No such item could be identified at Parts Select or at Kitchen Aid. After looking at item after item on the parts diagram it was determined the new name was a bin Thermostat not to be confu
... Read more
sed with the Thermistor, Ice control.
Replacement was quick and easy and took 5-10 minutes. Working fine now.
Replacement was quick and easy and took 5-10 minutes. Working fine now.
Read less
Was this instruction helpful to you?
Thank you for voting!