ZDIS15CSSJ General Electric Ice Maker

I loosened the compression nut on the valve with my fingers and pulled the water line free from the valve. On the other end, I just pulled it from the hose clamp. Installation in reverse. Force the water line into the fitting on top, Slide the old nut over the line on the bottom. Screw the nut onto the valve. Reach inside the freezer and turn on the ice maker. Done. Before replacing the cardboard grill, you should vacuum the coils on the bottom, front and back. If practical, push it outside and blow it out with an air compressor or a leaf blower.

I replaced both the punp and water line. the website depicting the repair parts was the best i ever worked with. The parts were high quality delivered on time and easy to install. Total job cost $30 as opposed the cost of of a service man or a new refrig.

Unit was failing to make ice as a result of cutting grid fail (broken cutting wire disrupted circuit so no heating) and corresponding ice build up on cooling plate. Defective cutting grid swapped out - replacement part had superior design to OEM and was made of comparable to superior materials. Very satisfied.