HR3850B Makita Hammer - Parts

This is a brush holder cap for a variety of power tools. The cap contains the brush in the holder. It protects the motor brush on the motor brush holder by covering it. To remove the cap, you will nee...

This cord is a genuine Makita replacement part and is sold individually. This cord is made for the double insulated tools shown below It is a two wire cord with two prongs and does not need a ground wire.

• This cord guard is a genuine Makita replacement part and is sold individually. • Cord guards, also called cord protectors, are designed to slide onto your cord and fit securely at the end, wher...

This genuine OEM steel ball is found within the housing of your power tool. It serves as a detent mechanism, securing the shift knob in various positions to allow for the selection of different operat...

Set of 2 Carbon Brushes with wire leads and brush springs attached. The set contains genuine Makita replacement parts, and comes packaged in a Makita retail box. This brush set will fit the Makita ...

This manufacturer sourced replacement pin is made out rubber and it is sold individually. It acts as a cushion/spacer in a variety of Makita power tools. This is a standard piece of hardware and it ha...

This Trigger switch has 4 terminals. This is an authentic Makita replacement part that is sold individually. Switches are commonly replaced parts in power tools, handling all on/off and variable sp...

This genuine manufacturer approved hammer grease is sold individually. This petroleum based grease is designed for use with Makita hammers. It helps to lubricate the system allowing for easy movement ...

This item is an authentic Makita part that has been sourced from the original manufacturer and is intended to be used with demolition hammers. The plastic dust cover is used to house and protect the s...

This Ball Bearing is sealed on both sides. This is a genuine Makita replacement part that is sold individually. • Ball bearings minimize friction between 2 parts in your tool that would otherwise...

This is an authentic Makita replacement part that has been sourced from the original manufacturer to be used with circular saws, table saws, masonry saws, planers, demolition hammers, and angle cutter...

This part is available individually. The spring washer fits between the wing nut and the flat washer. This washer is small and will need to be replaced if it gets lost or if it breaks. It is made out ...