GA4542C01 Makita Grinder

Set of 2 Carbon Brushes with wire leads and brush springs attached. The set contains genuine Makita replacement parts, and comes packaged in a Makita retail box. rnThis brush set will fit the Makita t...

This power cord is for power tools. Unplug the power tool before installing this part. Wear work gloves to protect your hands.

Genuine Makita replacement part, this item is sold individually. The purpose of this Clamp Nut is to secure the Grinding wheel to the spindle of the Grinders shown below. To tighten the nut to the spi...

Engineered for use in power tool motor assemblies, this sealed ball bearing helps support smooth rotation while reducing friction, noise, and wear during operation. Its precision design contributes to...

This Ball Bearing is sealed on both sides. This is a genuine Makita replacement part that is sold individually. • Ball bearings are used to reduce friction between rotating parts. The balls or r...

This O-ring creates a tight seal within the spindle lock assembly, helping prevent oil leaks while keeping dust and debris out of the gearbox. Made from durable rubber and measuring approximately 0.25...

This manufacturer sourced replacement pin is made out rubber and it is sold individually. It acts as a cushion/spacer in a variety of Makita power tools. This is a standard piece of hardware and it ha...

it is an authentic high quality Makita replacement part that is specially manufactured for use with sanders and grinders. This is the insulation washer for the armature, please make sure to check appr...

This part is available as an individual replacement part. The magnet sleeve goes between the stop ring and the wave washer. It is made of plastic and will require replacing if it becomes broken. A scr...

This is an authentic replacement part manufactured for Makita products. This metal washer has many applications usually used as a spacer for bearings. This washer is sold individually, please see mode...

This is an authentic Makita replacement part manufactured for use with angle grinders and circular saws. The sealed bearing is used to reduce friction between a rotating shaft and fixed housing or ass...

This tapping screw is an authentic hardware that is supplied by original tool manufacturer for use with a variety of Makita power tools. It has multiple uses depending on the model of your unit, pleas...