Models
>
FV21M2WSFF
FV21M2WSFF Gibson Freezer
Jump to:
Find Part by Name
Keep searches simple, eg. "belt" or "pump".
Diagrams for FV21M2WSFF
Viewing 3 of 3
Keep searches simple, eg. "belt" or "pump".
This kit includes both the left and right side end caps.
In Stock
Order now and your part arrives by Apr 9
In Stock
Order now and your part arrives by Apr 9
$19.63
This multi-use screw fits various appliances and tools such as, freezers, refrigerators, wall ovens, washers, ranges, dishwashers, dryers, microwave oven combos, combos, wine and beverage coolers. *Pl...
In Stock
Order now and your part arrives by Apr 9
In Stock
Order now and your part arrives by Apr 9
This gasket is intended for use with upright freezers.
This white door gasket is used to make an air-tight seal for the cabinet when the door is closed
No Longer Available
In Stock
Order now and your part arrives by Apr 9
In Stock
Order now and your part arrives by Apr 9
In Stock
Order now and your part arrives by Apr 9
On Order
Questions and Answers
We're sorry, but our Q&A experts are temporarily unavailable.
Please check back later if you still haven't found the answer you need.
Common Problems and Symptoms for FV21M2WSFF
Viewing 4 of 4Frost buildup
Fixed by these parts
How to fix it
Fridge too warm
Fixed by these parts
How to fix it
Won’t start
Fixed by these parts
How to fix it
Will Not Start
Fixed by these parts
How to fix it
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
- Customer:
- Sharon from Green Valley Lake, CA
- Parts Used:
- 3206261
- Difficulty Level:
- Easy
- Total Repair Time:
- 30 - 60 mins
- Tools:
- Screw drivers
The freezer was going into alarm
We loosened all the screws around the door and slid out the old gasket.
We then slid the new gasket behind the panel and screwed the screws back in place.
We then slid the new gasket behind the panel and screwed the screws back in place.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Linda from Gurnee, IL
- Parts Used:
- 216594300
- Difficulty Level:
- Easy
- Total Repair Time:
- 30 - 60 mins
- Tools:
- Screw drivers
The compressor would not run.
I removed the cover, used a multimeter to test the compressor circuit, and found the compressor start relay to be defective.
Ordered a new one and installed it when it arrived.
Ordered a new one and installed it when it arrived.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Sherman from Tuttle, OK
- Parts Used:
- 216594300
- Difficulty Level:
- Easy
- Total Repair Time:
- 30 - 60 mins
- Tools:
- Screw drivers
Compressor was short cycling
Removed the cowling with a square drive screw driver, removed the spring clip from the cover of the compressor controls with a screw driver, pulled off the old compressor start relay and replaced it with the new part. Since other problems could have caused the compressor to short cycle this was a "replace the part and hope it would work"
... Read more
since that would be the most common reason and it was not a very expensive part.
Read less
Was this instruction helpful to you?
Thank you for voting!