This authentic replacement part is specially designed for Briggs and Stratton generators. It is supplied from the original equipment manufacturer. This is an important component of the unit which regu...
This is a brush holder assembly for your generator. Brushes conduct electric currents to provide power in the motor of your unit. The brush assembly is mounted into a bearing carrier, and is wired to ...
This is an authentic manufacturer made replacement part which is specially designed for use with Craftsman pressure washers. The wheels are attached to the bottom of the pressure washer and are used f...
Keep in mind that this high-quality part is made of metal and is sold individually. A set of pliers might be helpful during the installation of this part. The e-ring fits onto the wheel and will need ...
This is the replacement battery that is specially designed for use with Briggs and Stratton portable generators. It is an authentic item that is supplied directly from the original equipment manufactu...
This is a genuine Briggs & Stratton part sourced directly from the manufacturer for use in generators. The outlet is made of metal and plastic and attaches to the control panel. A screwdriver may be n...
The circuit breaker is made out of plastic and metal. This authentic item is supplied directly from the original equipment manufacturer for use with generators made by Briggs & Stratton. This item is ...
This replacement flange nut is an authentic manufacturer-sourced component which is specially designed for use with Briggs and Stratton equipment. It is the hardware which has multiple applications de...
This is an OEM part sourced directly from the manufacturer. The circuit breaker boot is commonly found in portable generators from Briggs & Stratton. This part is made of high-quality plastic, and i...
This is available as an individual replacement. The outlet is part of the control panel assembly. When replacing this item a wrench may be needed. It is made of metal and plastic and will need to be r...
This is an authentic Briggs & Stratton replacement part. The bearing is commonly found in generators. This part is made of metal, and is used to allow the rotor assembly to spin freely within the st...
Special Order
Questions and Answers
Ask our experts a question about this part and we'll get back to you as soon as possible!
1 question answered by our experts.
< Prev
1
Next >
Sort by:
Search filter:
Clear Filter
Your search term must have 3 or more characters.
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
Sorry, we couldn't find any existing answers that matched. Try using some different or simpler keywords, or submit your new question by using the "Ask a Question" button above!
Harry
May 13, 2023
I installed the AVR and it produced AC immediately. The only problem is it stopped producing AC after running a few minutes or until it warmed up. I waited a few minutes and restarted the generator and it provided AC once again until warming. Can you tell me why running the generator would cause this interruption of power?
Thank you.
For model number 030359-0
Hi Harry, thank you for your inquiry. According to our research, the issue might be caused if the AVR voltage gain is set too low to respond to the load being applied. The issue might also be caused by a fault in the winding powering the AVR. Checking the AVR windings for continuity using a multimeter might help. If the AVR control regulator, part number FIX9270265, is faulty you will need to replace it. Good luck with the repair!
