Models
>
PNRV18ZBL01
PNRV18ZBL01 General Electric Water Filter System
Jump to:
Find Part by Name
Keep searches simple, eg. "belt" or "pump".
Diagrams for PNRV18ZBL01
Viewing 1 of 1Keep searches simple, eg. "belt" or "pump".
In Stock
In Stock
Used with Smart Water reverse osmosis drinking water systems.
No Longer Available
Special Order
In Stock
Special Order
Special Order
Special Order
Used with Smart Water reverse osmosis drinking water systems.
No Longer Available
Questions and Answers
We're sorry, but our Q&A experts are temporarily unavailable.
Please check back later if you still haven't found the answer you need.
Common Problems and Symptoms for PNRV18ZBL01
Viewing 1 of 1Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
- Customer:
- Swaroop from Chandler, AZ
- Parts Used:
- WS15X10011, WS08X10002
- Difficulty Level:
- Easy
- Total Repair Time:
- 15 - 30 mins
- Tools:
- Screw drivers, Wrench (Adjustable)
RO Faucet leaking
First I removed the round faucet handle, slide the black knob behind that opens and closes the water flow. Secondly dis-lodged the base of the faucet up from the electronic base. Little bit of pressure is required. If necessary use screw driver to prea. Carefull might break the plastic base of the faucet. Once removed, using adjustable wr
... Read more
ench, remove the bottom and top nuts of the pipe connecting faucet. Remove the old gasket. Do not reuse this gasket as it will leak. Screw-in the new faucet with gasket to base with water pipe using 2 nuts and wrench. Tighten lower nut as hard as you can, but top nut that secures the base and faucet liver, make sure it is good enough. Position base and front of faucet exactly in middle, so that black knob falls exactly behind the faucet arm. Put base along with faucet back onto electronic base, slide in the black knob and finally put faucet arm(lever) straight down. If necessary, grease O-rings on faucet arm(lever) with silicon.
Read less
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- william from tamp, FL
- Parts Used:
- WS21X10001
- Difficulty Level:
- Easy
- Total Repair Time:
- 30 - 60 mins
RO senser stopped working
unplugged 2 wires
disconnected and reconnected 2 water input and 2 water output connectors, new batteries and it works
disconnected and reconnected 2 water input and 2 water output connectors, new batteries and it works
Was this instruction helpful to you?
Thank you for voting!