Models
>
GMR06AAPWW
GMR06AAPWW General Electric Refrigerator
Jump to:
Find Part by Name
Keep searches simple, eg. "belt" or "pump".
Diagrams for GMR06AAPWW
Viewing 4 of 4
Manuals & Guides for GMR06AAPWW
Click to downloadKeep searches simple, eg. "belt" or "pump".
In Stock
Order now and your part arrives by Aug 1
Special Order
This evaporator fan motor is located in the back of the freezer, and circulates air over the refrigerator coils. These coils will convert the heat into cool air, which is then circulated.
No Longer Available
Special Order
This part helps maintain a constant temperature within the appliance.
No Longer Available
$61.95
The filter dryer filters refrigerant that travels through the sealed system of the refrigerator.
In Stock
Order now and your part arrives by Aug 1
Special Order
Common Problems and Symptoms for GMR06AAPWW
Viewing 3 of 3Noisy
Fixed by these parts
How to fix it
Will Not Start
Fixed by these parts
How to fix it
Fridge too cold
Fixed by these parts
How to fix it
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
- Customer:
- Liz from Alexandria, VA
- Parts Used:
- WR12X10651
- Difficulty Level:
- Easy
- Total Repair Time:
- Less than 15 mins
- Tools:
- Screw drivers
Plastic handle had cracked
Only tool needed was a screwdriver --unscrew the old one, (cleaned the door!), then screwed the new handle back on. Five screws. I did also break part of the old handle out from under the GE logo on the old handle so I could install the logo on the new handle. It was easy to do but annoying that it didn't come with either the logo alr
... Read more
eady installed in the new handle, or included in the order. The new handle had the impression in place and would have looked like it was missing something!
Read less
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- SHawn from El Campo, TX
- Parts Used:
- WR09X10038
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
- Tools:
- Screw drivers
Refrigerator would not come on
I removed the one screw holding cover in place contained the thermostat . Next , I removed the thermostat from the plastic housing. NO screws, it just clippped in. I replaced the old with the new and reinstalled the cover. 2 minutes max. Sears said the part was obsolete but Partselect had what I needed.
Was this instruction helpful to you?
Thank you for voting!