Models
>
86776474
86776474 Kenmore Furnace
Jump to:
Find Part by Name
Keep searches simple, eg. "belt" or "pump".
Models for 86776474
Click on the best match to narrow your results.
- 86776474 Kenmore Furnace (Kenmore Furnace Model 867.76474 (86776474, 867 76474) Parts)
- 867764741 Kenmore Furnace (Kenmore Furnace Model 867.764741 (867764741, 867 764741) Parts)
- 867764742 Kenmore Furnace (Kenmore Furnace Model 867.764742 (867764742, 867 764742) Parts)
- 867764743 Kenmore Furnace (Kenmore Furnace Model 867.764743 (867764743, 867 764743) Parts)
Keep searches simple, eg. "belt" or "pump".
In Stock
Special Order
Special Order
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
- Customer:
- William from Placentia, CA
- Parts Used:
- WP37001308
- Difficulty Level:
- Easy
- Total Repair Time:
- 30 - 60 mins
- Tools:
- Nutdriver, Screw drivers
Gas dryer was not getting hot.
Removed top of dryer and front panel. Keeping the front door closed I was able to start the unit and observe if the gas was igniting to heat the unit.
Found that no flame was present.
Examined the ignitor (found the locatino after utilizine this website parts diagram) and noticed it was cracked.
Ordered the new part and it ... Read more arrived two days later. Simple installation and ta daaa....ignitor works, hot dryer again.
*Only reason it took over half an hour was because I cleaned out all the internal vents while the unit was opened.
Basic mechanical abilities required here but remember to unplug the unit while working on it!
Found that no flame was present.
Examined the ignitor (found the locatino after utilizine this website parts diagram) and noticed it was cracked.
Ordered the new part and it ... Read more arrived two days later. Simple installation and ta daaa....ignitor works, hot dryer again.
*Only reason it took over half an hour was because I cleaned out all the internal vents while the unit was opened.
Basic mechanical abilities required here but remember to unplug the unit while working on it!
Read less
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- RICHARD from LINDSTROM, MN
- Parts Used:
- WP37001308
- Difficulty Level:
- Really Easy
- Total Repair Time:
- 15 - 30 mins
- Tools:
- Screw drivers, Socket set
Would not lite
Remove igniter and replaced easy to do
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Garrett from PHILADELPHIA, PA
- Parts Used:
- WP37001308
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
- Tools:
- Nutdriver
Gas smell
After removing the front panel, the igniter just just snaps into the bracket.
Was this instruction helpful to you?
Thank you for voting!