FUM17SAARWH General Electric Freezer - Instructions
Jump to:
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
- Customer:
- Hazel from FRIENDSWOOD, TX
- Parts Used:
- WR14X28402
- Difficulty Level:
- Difficult
- Total Repair Time:
- 30 - 60 mins
- Tools:
- Screw drivers
Gasket not sealing
Per the UTube video ...
Once the gasket was on, the door would not seal.
Gasket was removed and placed in dryer again to "soften" but to no avail on the second try.
When we received the package, the box was ripped open and only the wadded up gasket in the box. Don't know if someone just shoved it in or what. I think this is what caused the issue with it not sealing. Also no instructions except on your website. We ended up putting on the original gasket and sealed the cut on the gasket with tape. Freezer seals well and no leaks or issues. I still have the gas but no clue what to do with it if we can't get it to work. Is there a refund available?
Once the gasket was on, the door would not seal.
Gasket was removed and placed in dryer again to "soften" but to no avail on the second try.
When we received the package, the box was ripped open and only the wadded up gasket in the box. Don't know if someone just shoved it in or what. I think this is what caused the issue with it not sealing. Also no instructions except on your website. We ended up putting on the original gasket and sealed the cut on the gasket with tape. Freezer seals well and no leaks or issues. I still have the gas but no clue what to do with it if we can't get it to work. Is there a refund available?
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Jerry from Marion, KY
- Parts Used:
- WR07X10015
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
- Tools:
- Pliers, Screw drivers
Tempture Got Hot In Box. The Compressor Was Making A Clicking Sound.
First I tested the compressor with my v. O. Meter and it was ok I then found the relay was bad I removed the start relay by puling it off the compressor & removed the run wire & start wire watching not to cross them & reversed to re install. Now it runs good again.
Was this instruction helpful to you?
Thank you for voting!