Models
>
FCF14SUAWW
FCF14SUAWW General Electric Freezer
Jump to:
Find Part by Name
Keep searches simple, eg. "belt" or "pump".
Diagrams for FCF14SUAWW
Viewing 3 of 3Keep searches simple, eg. "belt" or "pump".
This key is for freezers. If your key will not lock or unlock the freezer door, check it to see if it has been bent or damaged. If it has been damaged, you should look to replace it to avoid damaging ...
No Longer Available
The thermostat senses that the heat near the cooling coils has reached the desired temperature.
No Longer Available
Special Order
Special Order
Special Order
In Stock
Order within the next 11 hrs and your part ships today!
Special Order
Special Order
Questions and Answers
We're sorry, but our Q&A experts are temporarily unavailable.
Please check back later if you still haven't found the answer you need.
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
- Customer:
- Ouida from Huntsville, AL
- Parts Used:
- WR24X10005
- Difficulty Level:
- A Bit Difficult
- Total Repair Time:
- 1- 2 hours
- Tools:
- Pliers, Screw drivers
Moldy Gasket
This freezer was given to me by a neigbor. It had set closed/unplugged for over a year. The gasket was so moldy I couldn't clean it. Unplug the freezer! I removed the old gasket pins using needle nose pliers. There were about 50 plastic pens holding the gasket and inside cover of the freezer lid (chest freezer) The plastic pens were
... Read more
difficult to remove. The insulation was wet so I braced the lid open and let the insulation dry for a couple of days. When the insulation was dry I attached a plastic pen at each corner of the gasket and then placed pens at even intervals around the rest of the gasket.. None of the holes lined up past the 3rd hole so I used a punch to make the necessary holes. The instructions say to put a bead of silicone gel around the outer edge of the gasket. I haven't done that yet but plan to do that last step.
Read less
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Jerry from Elverta, CA
- Parts Used:
- WR09X10154
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
- Tools:
- Screw drivers
freezer kept icing up on the coils would only get down to 20 degrees.
unplug the freezer. remove the 2 screws holding the timer, unplug the electrical fitting w/4 prongs. reverse the steps and you are done.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- james from las cruces, NM
- Parts Used:
- WR01X26468
- Difficulty Level:
- Easy
- Total Repair Time:
- Less than 15 mins
The freezer was missing the key
I ordered a pair of new keys from Parts Select and found the website extremely easy to use. I found the key I needed in less than 10 minutes and ordered the item. The key woked perfectly. Delivery was prompt and the cost was resonable. I have bookmarked the site for future use. thank you. James
Was this instruction helpful to you?
Thank you for voting!