Models > FUF17DACRWH

FUF17DACRWH General Electric Freezer

Jump to:

Find Part by Name

Keep searches simple, eg. "belt" or "pump".

Diagrams for FUF17DACRWH

Viewing 3 of 3
Keep searches simple, eg. "belt" or "pump".
This key is for freezers. If your key will not lock or unlock the freezer door, check it to see if it has been bent or damaged. If it has been damaged, you should look to replace it to avoid damaging ...
No Longer Available
This shoulder screw is sold individually.
In Stock
$29.54
In Stock
On Order
This screw is sold individually. Size 8 - 18 x 0.31
Special Order
Special Order
$44.30
In Stock
No Longer Available
No Longer Available
$62.27
The filter dryer filters refrigerant that travels through the sealed system of the refrigerator.
In Stock
Sold individually - for upright freezers
Special Order
$12.30
In Stock

Questions and Answers

Be the first to ask our experts a question about this part!

Common Problems and Symptoms for FUF17DACRWH

Viewing 2 of 2
Frost buildup
Fixed by these parts
How to fix it
Will Not Start
Fixed by these parts
Fixing
How to fix it
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
Customer:
Paulette from Great Falls, MT
Parts Used:
WR02X12310
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins
Tools:
Screw drivers
The freezer door was catching when opened and frost was building inside telling me that the seal wasn't good.
I called the local GE dealer for repair. The repair person arrived and told me that he could not get the part. The freezer was too old. Then he charged me $60 for coming out. I went online and did a search for parts with the model number above. I found Partselect.com and the diagrams showed which part I needed. It was in stock and I ordered it. My husband and I removed the door to the freezer, pushed the part into the hole at the bottom of the door and put the door back on its hinges. It works perfectly. Thank you.
12 of 16 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Customer:
Jerry from Elverta, CA
Parts Used:
WR09X10154
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins
Tools:
Screw drivers
freezer kept icing up on the coils would only get down to 20 degrees.
unplug the freezer. remove the 2 screws holding the timer, unplug the electrical fitting w/4 prongs. reverse the steps and you are done.
4 of 8 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Customer:
Jerry from Marion, KY
Parts Used:
WR07X10015
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins
Tools:
Pliers, Screw drivers
Tempture Got Hot In Box. The Compressor Was Making A Clicking Sound.
First I tested the compressor with my v. O. Meter and it was ok I then found the relay was bad I removed the start relay by puling it off the compressor & removed the run wire & start wire watching not to cross them & reversed to re install. Now it runs good again.
1 person found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!