Models
>
FCM15DAAWH
FCM15DAAWH General Electric Freezer
Jump to:
Find Part by Name
Keep searches simple, eg. "belt" or "pump".
Diagrams for FCM15DAAWH
Viewing 3 of 3
Keep searches simple, eg. "belt" or "pump".
This key is for freezers. If your key will not lock or unlock the freezer door, check it to see if it has been bent or damaged. If it has been damaged, you should look to replace it to avoid damaging ...
No Longer Available
In Stock
This part helps the compressor kick on and off while maintaining a constant temperature to keep things frozen in your freezer.
No Longer Available
$62.27
The filter dryer filters refrigerant that travels through the sealed system of the refrigerator.
In Stock
Special Order
The start relay briefly boosts the compressor, and then shuts off as soon as the motor gets up to speed.
No Longer Available
Special Order
Special Order
Questions and Answers
We're sorry, but our Q&A experts are temporarily unavailable.
Please check back later if you still haven't found the answer you need.
Common Problems and Symptoms for FCM15DAAWH
Viewing 1 of 1
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
- Customer:
- Ouida from Huntsville, AL
- Parts Used:
- WR24X10005
- Difficulty Level:
- A Bit Difficult
- Total Repair Time:
- 1- 2 hours
- Tools:
- Pliers, Screw drivers
Moldy Gasket
This freezer was given to me by a neigbor. It had set closed/unplugged for over a year. The gasket was so moldy I couldn't clean it. Unplug the freezer! I removed the old gasket pins using needle nose pliers. There were about 50 plastic pens holding the gasket and inside cover of the freezer lid (chest freezer) The plastic pens were
... Read more
difficult to remove. The insulation was wet so I braced the lid open and let the insulation dry for a couple of days. When the insulation was dry I attached a plastic pen at each corner of the gasket and then placed pens at even intervals around the rest of the gasket.. None of the holes lined up past the 3rd hole so I used a punch to make the necessary holes. The instructions say to put a bead of silicone gel around the outer edge of the gasket. I haven't done that yet but plan to do that last step.
Read less
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- james from las cruces, NM
- Parts Used:
- WR01X26468
- Difficulty Level:
- Easy
- Total Repair Time:
- Less than 15 mins
The freezer was missing the key
I ordered a pair of new keys from Parts Select and found the website extremely easy to use. I found the key I needed in less than 10 minutes and ordered the item. The key woked perfectly. Delivery was prompt and the cost was resonable. I have bookmarked the site for future use. thank you. James
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Joyce from Citrus Heights, CA
- Parts Used:
- WR24X10005
- Difficulty Level:
- A Bit Difficult
- Total Repair Time:
- 30 - 60 mins
- Tools:
- Screw drivers
freezer not keeping frost free & gasket was hard
Ordered from PartSelect, got the gasket very quickly && even has the best cost over SEARS & 3 other places. I followed the instructions in the pkg. but it may be that the freezer is too old or the lid needs to be readjusted. Who knows but would suggest this company to anyone for parts! Thanks again!P.S. it took longer than most
Was this instruction helpful to you?
Thank you for voting!