Models
>
GFC100--01
GFC100--01 General Electric Food Waste Disposer
Jump to:
Find Part by Name
Keep searches simple, eg. "belt" or "pump".
Keep searches simple, eg. "belt" or "pump".
In Stock
Special Order
Special Order
Special Order
Special Order
Questions and Answers
We're sorry, but our Q&A experts are temporarily unavailable.
Please check back later if you still haven't found the answer you need.
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
- Customer:
- Aubrey from Hugo, OK
- Parts Used:
- WC3X124
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
Splash guard worn out
pulled out the old and stuck in the new--so easy a caveman could do it.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Tom from ORLANDO, FL
- Parts Used:
- WC3X124
- Difficulty Level:
- Very Easy
- Total Repair Time:
- Less than 15 mins
old one wore out and had shrunk and coming loose.
Turn off power to unit (switch off) Put rubber gloves on and pulled out old guard. Then cleaned the area on the sides and the under the lip with wet paper towels. Crud had built up. Once clean push the new guard in. Since it was new it was tight .push down moving finger pressure around until it seated. Works fine.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- robert from coral gables, FL
- Parts Used:
- WC3X124
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
old splash gard became loose, felt always into grinder
just wet the surface of the new part and pushed it with some force into its place. It was real easy
Was this instruction helpful to you?
Thank you for voting!