Models
>
111P05
111P05 ((0008-F1)) Briggs and Stratton Engine
Jump to:
Find Part by Name
Keep searches simple, eg. "belt" or "pump".
Keep searches simple, eg. "belt" or "pump".
In Stock
In Stock
In Stock
$6.39
This part is the replacement gasket for the crankcase on your engine. The gasket helps to create a seal on the crankcase and prevent leaks. If you notice that your engine is not running at peak perfor...
In Stock
In Stock
In Stock
In Stock
In Stock
In Stock
In Stock
In Stock
In Stock
Questions and Answers
We're sorry, but our Q&A experts are temporarily unavailable.
Please check back later if you still haven't found the answer you need.
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
- Customer:
- Laird from North Las Vegas, NV
- Parts Used:
- 592172
- Difficulty Level:
- Difficult
- Total Repair Time:
- More than 2 hours
- Tools:
- Nutdriver, Pliers, Screw drivers, Socket set
Bought Troy Built pressure Washer at garage Sale for $30.00 leaked fuel
I have a solid understanding of small engines. This pressure washer was used twice in 2013, when purchased. Sat in a garage for a couple of years with gas in tank and carburetor. Owner was moving and after 7 years of moving it around he sold it at a garage sale.
I took it home and took off gas tank and thoroughly cleaned it. Then we ... Read more nt through the carburetor and let soak in cleaner. Cleaned up the spark plug, tested and has good spark. reinstalled carburetor but would not start. I knew I had gas issues. I ordered a carburetor kit and replace the needle valve and seals. Still would not start. Ordered a new carburetor and spark plug. Installed both. Two pulls and it runs like new. Advice: don't try to clean out old carburetor, just buy a new one and install.
I took it home and took off gas tank and thoroughly cleaned it. Then we ... Read more nt through the carburetor and let soak in cleaner. Cleaned up the spark plug, tested and has good spark. reinstalled carburetor but would not start. I knew I had gas issues. I ordered a carburetor kit and replace the needle valve and seals. Still would not start. Ordered a new carburetor and spark plug. Installed both. Two pulls and it runs like new. Advice: don't try to clean out old carburetor, just buy a new one and install.
Read less
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Darrel from SARASOTA, FL
- Parts Used:
- 796495
- Difficulty Level:
- Very Difficult
- Total Repair Time:
- 30 - 60 mins
- Tools:
- Nutdriver, Screw drivers
The exhaust system just fell off the motor
I ordered the parts as there were only three screws and two bolts that needed to come out and then thenew ones go back in. Everything went just as planned...….well except the two bolts that where included by Briggs and Stratton appear to be 1/8-1/4" too short and now both of the threaded holes in the engine are now stripped and the quick
... Read more
easy repair is now a bust and not repairable by me.
This has nothing to do with PartSelect.com as they just shipped the Briggs and Stratton part box.
This has nothing to do with PartSelect.com as they just shipped the Briggs and Stratton part box.
Read less
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Kim from KENNER, LA
- Parts Used:
- 796503
- Difficulty Level:
- Very Easy
- Total Repair Time:
- Less than 15 mins
Screw in new dipstick, check oil level
Very well
Was this instruction helpful to you?
Thank you for voting!