1754-1 (SER 566-3100) Milwaukee Electric Drill

This is an OEM carbon brush, sold individually. Your tool will require two of these, so please be sure to order what you need. It is best practice to replace both carbon brushes at the same time, even...

This cord is a genuine Milwaukee replacement part and is sold individually. This cord is used on the Milwaukee tool listed below It is a 3 wire cord with 3 prongs and does need to be grounded to the tool.

This is a screw and it is used on a variety of power tools. This part has a slotted pan head, and needs a Torx screwdriver to tighten or loosen. The measurements of the screw are #8 in diameter, with ...

This Torx screw fits a variety of lawn and gardening tools. The screw has a diameter of 8, 16 thread counts, and 5/8 inches for the length. Refer to diagram provided by the manufacturer for further in...

This authentic replacement part is designed for use with Milwaukee drills/drivers. Ball bearings are used to reduce friction between rotating parts. The balls or rollers take the load and spin, distri...

This switch is an OEM genuine replacement part. It is used in Milwaukee electric drills/drivers. Included is one (1) each of: switch handle casing, trigger switch, reversing switch, and cord clamp. A ...

This replacement handle grip is a high quality OEM sourced part. It is designed for use with Milwaukee power tools. This is the side handle that provides a safe and stable grip of your tool. This item...

This is an authentic part produced by the original manufacturer. It is compatible with Milwaukee power tools including grinders, sanders, and polishers. Ball bearings secure moving parts, allowing for...

A genuine replacement part that is supplied by original equipment manufacturer for use with Milwaukee power tools. This woodruff key helps to secure the pinion gears to the spindle, for correct locati...

This replacement thrust washer is an authentic manufacturer sourced item that is commonly used on Milwaukee power tools. The purpose of a washer is to re-distribute the pressure evenly providing a tig...

This is an authentic Milwaukee replacement part that has been sourced from the original manufacturer to be used with drill presses. The sealed ball bearing is used to reduce friction between the rotat...

This is an authentic Milwaukee replacement part. The special brush tube is used to house the carbon brushes and the tube allows them to press against the commutator on the armature. The brush tubes ar...