Models > PE550

PE550 (Type 1) Weed Eater Edger

Jump to:

Find Part by Name

Keep searches simple, eg. "belt" or "pump".

Diagrams for PE550

Viewing 3 of 3
Keep searches simple, eg. "belt" or "pump".
This fuel filter is for lawn and garden equipment engines. Fuel filter cleans the fuel before it reaches the carburetor. Work in a well-ventilated area when installing this part. Drain the fuel...
In Stock
Order within the next 58 mins and your part ships today!
The fuel line carries the fuel from the fuel tank into the carburetor. This particular fuel line can be used in various lawn and garden equipment, such as trimmers and blowers. This clear rubber part ...
In Stock
Order within the next 58 mins and your part ships today!
In Stock
Order within the next 58 mins and your part ships today!
$6.62
In Stock
Order within the next 58 mins and your part ships today!
This is a carburetor repair kit, but it may also be known as a carburetor gasket or diaphragm kit, for your lawn equipment. This assembly is used to replace the gaskets in your machine. If you are hav...
In Stock
Order within the next 58 mins and your part ships today!
In Stock
Order within the next 58 mins and your part ships today!
$6.21
In Stock
Order within the next 58 mins and your part ships today!
On Order
$11.20
In Stock
Order within the next 58 mins and your part ships today!
In Stock
Order within the next 58 mins and your part ships today!
No Longer Available
This part is the rope retain screw for your outdoor power equipment. It is black in color and is a flathead screw. It is sold individually and is an authentic OEM part sourced directly from the manufacturer.
In Stock
Order within the next 58 mins and your part ships today!

Questions and Answers

We're sorry, but our Q&A experts are temporarily unavailable.
Please check back later if you still haven't found the answer you need.

Common Problems and Symptoms for PE550

Viewing 2 of 2
Will Not Start
Fixed by these parts
Fixing Fixing
How to fix it
Engine stops after a few seconds or minutes
Fixed by these parts
Fixing
How to fix it
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
Customer:
Paul from FLORISSANT, MO
Parts Used:
530071258
Difficulty Level:
Easy
Total Repair Time:
30 - 60 mins
Tools:
Screw drivers
Broken teeth on both large and small gears
Remove the gear assembly by removing the three Torx screws holding it to the main body, remove gas tank from assembly and set aside without removing gas lines. Remove cover, with blade still installed, that gains access to the gears, remove the large gear and wash out the grease with gasoline. Put penetrating oil like PB Blaster or Liquid Wrench on the end of the bolt at the bottom of the bowel-shaped clutch bell and let it work in. Then, take an Allen wrench that fits the bolt in the small gear and clamp it in a vise with the short end pointing straight up. Set the recess of the bolt on the Allen wrench. This will put the bowl-shaped clutch bell that has 4 holes in it up. Take 2 #2 Phillip's screwdrivers and put them in one of the holes directly across from each other so they form an "X" with the right screwdriver closest to you and the left screwdriver behind the right one.. Then, pushing the screwdriver in the right hand and pulling the screwdriver in the left hand will remove the clutch bell in a counter-clockwise motion. Reverse the above when installing a new gear.
7 of 9 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!