DDC4397VSL Whirlpool Dryer - Parts

This OEM kit comes with two ignition coils (one three-terminal boost/hold coil, and one two-terminal secondary coil). Usually only one of them burns out, but you should replace them as a set as both h...

This belt has a length of 87 inches, width of 1/4”, flat, with 4 ridges.

This part is the rear dryer drum bearing only. This part helps keep your dryer running smoothly as possible with as little noise as possible.

This 'M' series coil is both a boosting as well as a holding coil. It has three terminals.

This part is the replacement main valve coil for your dryer. It is black and white in color and has 2 terminals. It is approximately 1 inch long and 1 inch wide. The main valve coil opens the gas valv...

The adjustable leveling screws on the bottom of your dryer can be screwed in or out to lower or raise the leg level. If one of the leveling screws is stripped, damaged, or missing, you may not be able...

This front drum slide kit comes with two slides with the apppropriate mounting hardware.

This screw is sold individually.

Replaces "T" and "V" style motors. Includes two motor pulleys. If you have an older model dryer, the pulley may be pressed on or held on with a set screw. If pulley is pressed on, a new motor pulley must be ordered.

Also known as Flame Sensor/Detector.

This wheel attaches to the motor.