NG4819L53738 Speed Queen Dryer - Parts

This OEM kit comes with two ignition coils (one three-terminal boost/hold coil, and one two-terminal secondary coil). Usually only one of them burns out, but you should replace them as a set as both h...

The multi rib belt, which may also be called a dryer drum belt or a multi-v belt, helps to rotate the drum of the dryer. The belt wraps completely around the drum, around a tension pulley, and then ar...

This two inch wide idler pulley wheel is beige in color and is made of plastic. This pulley wheel comes with its own metallic bearing in its center.

This kit comes in two pieces: the catch and the clip.

This part replaces older two terminal switches.

This metal retaining ring is well under an inch long. Use it for your Maytag brand clothes washer or your clothes dryer.

This is a multi-use screw and can be used on a variety of appliances. The measurements of the screw are: 8/18 x 3/8. *Please note: the screw is sold individually. Refer to the manual provided by the m...

Part may differ in appearance, but functions same as original part.

This front cover spring retaining clip is not quite an inch long. It is made entirely of metal and is used for some washing machines.

This shaft is made to fit the center of the idler pulley wheel of many clothes dryers. It is less than two inches long, and is made of metal.

This gray levelling leg foot pad is made of rubber and is just over an inch in diameter. Sold individually.