41788980100 Kenmore Dryer - Parts

This ball-and-socket style bearing kit is used in your dryer to support the rear of the drum as it tumbles through the dry cycle. The bearing attaches on the inside of the rear panel of the dryer cabi...

The drum support bearing is an authentic OEM replacement part for your dryer. The bearing is used to support the drum and allow it to rotate smoothly and quietly. If your dryer is excessively noisy wh...

This thermal fuse limiter is used in dryers to monitor the temperature and make sure it does not overheat. The thermal fuse has a limit of 220 degrees Fahrenheit before the heating element and power a...

This door latch kit comes with the strike and the catch.

This coil ignition kit is used in dryers to open the gas valve when the dryer is on. This kit includes two coils. One is a two-wire secondary coil and the other is a three-wire booster coil. If your d...

This drum bearing bracket is for dryers. Drum bearing bracket holds and supports the drum bearing

This filter collects lint as it passes through the dryer vent.

This is a flat style ridgeless dryer belt.

Use this idler pulley assembly with gas or electric clothes dryer that has a flat dryer belt. ***Please NOTE: This part has been redesigned by the manufacturer and may not fit your appliance.

This part senses the flame for heat allowing the gas valve to open.

Used with dryers with a 27-inch drum.

This part ignites the gas within the dryer. Be sure to not handle this igniter by the gray part as it is very fragile.