DDC4492AAL General Electric Dryer - Parts

This rear drum bearing kit is a genuine OEM replacement for your dryer. The kit includes a shaft, ground strap, bracket, bearing and seven screws for installation. The bearing supports that back of th...

This belt has a length of 87 inches, width of 1/4”, flat, with 4 ridges.

This Genuine OEM door latch is designed for use with a wide range of GE clothes dryers. Constructed from a combination of durable metal and plastic, the latch is mounted onto the dryer frame to secure...

This part is the rear dryer drum bearing only. This part helps keep your dryer running smoothly as possible with as little noise as possible.

The adjustable leveling screws on the bottom of your dryer can be screwed in or out to lower or raise the leg level. If one of the leveling screws is stripped, damaged, or missing, you may not be able...

This front drum slide kit comes with two slides with the apppropriate mounting hardware.

This white idler pulley is used for many clothes dryers. A dryer's idler pulley wheel serves to help the belt to rotate the drum.

Be very careful to not handle the igniter by its gray part. Hold it by its white tip only.

This screw is sold individually.

This conversion kit changes the dryer from natural gas to liquid propane. Installation instructions are included.

Replaces "T" and "V" style motors. Includes two motor pulleys. If you have an older model dryer, the pulley may be pressed on or held on with a set screw. If pulley is pressed on, a new motor pulley must be ordered.

Also known as Flame Sensor/Detector.