CDG7000A Crosley Dryer - Instructions
Jump to:
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
- Customer:
- johnny from london, KY
- Parts Used:
- WP31001513
- Difficulty Level:
- Really Easy
- Total Repair Time:
- 15 - 30 mins
- Tools:
- Nutdriver, Screw drivers
Dryer Would Not Shut Off On Its Own
Ordered my part from partselect. Com (even easier than installation) unpluged the dryer,removed all knobs from face plate ,removed three phillips head screws across top ,removed two 5/16 head screws from timer( behind cycle knob) tilted back face plate unpluged one wire at atime from old timer placed back on new timer then reverced the process. Problem solved
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- walter from pittsburgh, PA
- Parts Used:
- WP31001513, WP31001484
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
- Tools:
- Nutdriver, Screw drivers
no heat
removed screws (3) holding console face...then lowered console. removed timer dial knob accessing machine nuts (2) holding timer in place. removed timer and transferred all spade connections, wire-for-wire. removed old timer resistor assembly and replaced with new. reassembled everything and tested with one very wet old sock. success.!!!!
smiled and finished martini on the patio.
smiled and finished martini on the patio.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- mary from Prescott, MI
- Parts Used:
- WP37001184
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
could noy start the dryer because the knob would not push in
the old knob slid off the post. The knob and post had one flat spot so it would be impossible to install the knob in the wrong position. Just pushed the new knob on the post and the dryer works like new again.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Gary from Irmo, SC
- Parts Used:
- WP31001484
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
- Tools:
- Screw drivers
Dryer wouldn't shut off in Auto Dry modes
Very simple-remove 3 screws that hold the Control Panel on, remove the two connectors and replace with new part in reverse order. Unfortunately, this did not fix the problem. Will be ordering complete timer assembly.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Ronald from Dardenne Prairie, MO
- Parts Used:
- WP31001513
- Difficulty Level:
- Easy
- Total Repair Time:
- 15 - 30 mins
- Tools:
- Nutdriver, Screw drivers
Dryer worked but no timing.
Part was perfect replacement thanks to online photos. Removed old timer switched leads one at a time from old to new timer and mounted new timer replaced back cover. Everything went fine.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Cara from oceanside, AL
- Parts Used:
- WP37001184
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
time broke in half and we've been using a plyers to turn on
It just pushed on and clicked
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- SHAWN from VERSAILLES, KY
- Parts Used:
- WP31001513
- Difficulty Level:
- Really Easy
- Total Repair Time:
- 15 - 30 mins
- Tools:
- Nutdriver, Screw drivers
dryer would not shut off
Unplug dryer as to avoid shocking yourself. Removed 3 screws on top of panel then remove cover then use nut driver to remove 2 screws from timer placed new timer next to old one and transferred wiring from old to new. Place new timer in place and mound with screws. Reinstall cover and 3 screws and you're done.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- pat from ANNAPOLIS, MD
- Parts Used:
- WP37001184
- Difficulty Level:
- Very Easy
- Total Repair Time:
- Less than 15 mins
The knob broke.
I lined the new knob up and pushed it on! No more pliers to time the dryer.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Chuck from GRANTS PASS, OR
- Parts Used:
- WP31001513
- Difficulty Level:
- Very Difficult
- Total Repair Time:
- More than 2 hours
- Tools:
- Nutdriver, Pliers
3 wires came loose from switch was twisted to connect.
It should have been easy but when some wires (3) came loose when I moved it to install it, I had a problem. The video that was run at a higher speed and too close up images you could not see which wire went where. Contacted Part Select and received no answer, so I tracked the wires down as much as I could on an old wiring diagram and hooked them up. I then connected the power, stood back and watched the switch smoke and blow circuits. No why to find the correct color wire to what part so I ended up having to buy a new dryer. Part Select has only sale people so don't expect help if something goes wrong. Good Luck
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- rey from san jose, CA
- Parts Used:
- WP37001184
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
i drop something on my knob thats how i broke my knob.its been 6 months i been looking for my knob until i see parts direct i put my order in just 2 days i received.
when i get my parts i just opened the packaged i put it in the pin knob it so simple.thank u very much parts direct for saving my dryer know its good for another 10 year.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Tamara from Hesperia, CA
- Parts Used:
- WP37001184
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
I had dryer in storage and boxes fell on the timer knob and broke it off.
The new one came. I put the new knob on. It looks and works great. Looks just like the original you can't even tell its been replaced. Tip: Don't stack boxes on top of your washer or dryer in storage unless you protect the knobs first, or they will get broken!
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Donald G from West Lafayette, OH
- Parts Used:
- WP37001184
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
A Broken Dryer Knob
Simple repair just removed old knob & installed the new one.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Donna from Elk River, MN
- Parts Used:
- WP37001184
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
timer knob was broken
pulled the old knob off and replaced it with the new skirt and knob
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- DeniseLittlefield from CENTERVILLE, UT
- Parts Used:
- WP37001184
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
dryer knob broken
Pulled old dryer knob off and put new one on. Similar to taking a knob off a gas stove burner. Easy peasy
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- D.L. from Coeburn, VA
- Parts Used:
- WP37001184
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
had to replace dryer timer knob--old one was broken
Old one had broken off knob shaft---just had to line up new knob on shaft and push in---couldn't have been more simple. PartSelect is great---received order within 2 days.
Was this instruction helpful to you?
Thank you for voting!