Models
>
CDE7000A
CDE7000A Crosley Dryer
Jump to:
Find Part by Name
Keep searches simple, eg. "belt" or "pump".
Keep searches simple, eg. "belt" or "pump".
$5.42
This is a multi-use screw and can be used on a variety of appliances. The measurements of the screw are: 8/18 x 3/8. *Please note: the screw is sold individually. Refer to the manual provided by the m...
In Stock
$55.60
This white timer knob and skirt assembly is used with for some clothes washers and clothes dryers. The entire assembly is three inches in diameter, and it is made of plastic. There is a gray trim arou...
In Stock
$11.10
This timer resistor assembly is two inches long. It is made of ceramic and metal.
In Stock
$280.92
This dryer timer is used to control the unit's cycles by regulating the length of time that power is directed to each setting.
In Stock
Special Order
In Stock
Questions and Answers
We're sorry, but our Q&A experts are temporarily unavailable.
Please check back later if you still haven't found the answer you need.
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
- Customer:
- johnny from london, KY
- Parts Used:
- WP31001513
- Difficulty Level:
- Really Easy
- Total Repair Time:
- 15 - 30 mins
- Tools:
- Nutdriver, Screw drivers
Dryer Would Not Shut Off On Its Own
Ordered my part from partselect. Com (even easier than installation) unpluged the dryer,removed all knobs from face plate ,removed three phillips head screws across top ,removed two 5/16 head screws from timer( behind cycle knob) tilted back face plate unpluged one wire at atime from old timer placed back on new timer then reverced the p
... Read more
rocess. Problem solved
Read less
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- walter from pittsburgh, PA
- Parts Used:
- WP31001513, WP31001484
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
- Tools:
- Nutdriver, Screw drivers
no heat
removed screws (3) holding console face...then lowered console. removed timer dial knob accessing machine nuts (2) holding timer in place. removed timer and transferred all spade connections, wire-for-wire. removed old timer resistor assembly and replaced with new. reassembled everything and tested with one very wet old sock. success
... Read more
.!!!!
smiled and finished martini on the patio.
smiled and finished martini on the patio.
Read less
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- mary from Prescott, MI
- Parts Used:
- WP37001184
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
could noy start the dryer because the knob would not push in
the old knob slid off the post. The knob and post had one flat spot so it would be impossible to install the knob in the wrong position. Just pushed the new knob on the post and the dryer works like new again.
Was this instruction helpful to you?
Thank you for voting!