Models
>
DV316BGW
DV316BGW Amana Dryer
Jump to:
Find Part by Name
Keep searches simple, eg. "belt" or "pump".
Diagrams for DV316BGW
Viewing 6 of 6Keep searches simple, eg. "belt" or "pump".
$16.32
This ten watt appliance light bulb is two inches tall. It is used with both washers and dryers.
In Stock
In Stock
$66.40
This part controls the temperature of the inside of the dryer drum and prevents the dryer from overheating.
In Stock
In Stock
In Stock
In Stock
$75.45
This drive belt is made to slip on the motor pulley to bring the basket up to the speed required and this makes the belt get wear and tear.
In Stock
In Stock
In Stock
In Stock
Questions and Answers
We're sorry, but our Q&A experts are temporarily unavailable.
Please check back later if you still haven't found the answer you need.
Common Problems and Symptoms for DV316BGW
Viewing 2 of 2Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
- Customer:
- JAMIE from VALLEY STREAM, NY
- Parts Used:
- WP35001191, WP35001087
- Difficulty Level:
- Really Easy
- Total Repair Time:
- 15 - 30 mins
- Tools:
- Screw drivers
Dryer did not turn when power was on.
Callled the service company to diagnose the problem. Watched him take machine apart. He found the problem. Told me the parts that I needed. Didnt know what they were. Went to partselect.com looked my model up and found parts and ordered. Followed same steps as repair guy: Two screws in back of machine then slide top off. Six screws in
... Read more
front to remove front door ( 4 screws on top 2 on bottom) Changed the thermostat and thermistor. Saved 320 dollars :)
Read less
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Vincent from Lusby, MD
- Parts Used:
- WP35001191
- Difficulty Level:
- Easy
- Total Repair Time:
- 1- 2 hours
- Tools:
- Screw drivers, Socket set
wet clothes in sensor dry mode(Samsung DV218)
top and the front had to be removed to get to the fan... the thermistor that sits in the exaust fan went bad... the heat would come on for a few minutes then turn off completely not getting to clothes dry.....
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Michael from Parrish, FL
- Parts Used:
- WP35001191
- Difficulty Level:
- Really Easy
- Total Repair Time:
- 30 - 60 mins
- Tools:
- Screw drivers
Dryer not heating
Had to pull the top off and the front of dryer with a few phillips screws and was able to get to the thermistor and I also replaced the heating coil because it was bad.The cause of the problem was because of a clogged up vent. It was a easy replacement.
Was this instruction helpful to you?
Thank you for voting!