This is a single rack track stop clip used to prevent the upper dish rack from sliding all the way out of the dishwasher. It is made of gray plastic and can wear with time. This is an easy repair that...
This authentic OEM part is a wash arm bearing ring for your dishwasher. The bearing ring works in conjunction with the bearing nut to hold the lower spray arm in place. A sign you may need to replace ...
This genuine OEM seal fits under the lower spray arm in your dishwasher. It is also known as a bearing ring and is used to create a seal between the spray arm and the sump housing. The part measures a...
This genuine OEM nut is used to hold the lower spray arm in place. The lower spray arm is found at the bottom of the dishwasher, and you will need to remove the bottom dish rack in order to replace th...
This dishwasher door gasket is a genuine replacement component designed to create a watertight seal between the tub and the door. Wrapping around the sides and top of the door, the gray rubber gasket ...
This dishwasher drain and wash impeller kit comes with both the drain and wash impeller, gaskets, chopper and installation screw. This part helps stop your dishwasher from leaking and helps with the ...
This water inlet valve should be located behind the lower kickplate panel in either the right or left corner. The attaching solenoids on the valve open and close according to the desired amount of wat...
This part acts as as safety mechanism that keeps the dryer from overheating. Once the dryer temperature reaches a certain point, this part will shut down power to the heating element.
This hose clamp extends from half an inch to an inch in diameter. It is made entirely of metal and is intended for use with Maytag brand washing machines.
This cap does not require the use of a o-ring seal.
In Stock
Order now and your part arrives by May 29
Questions and Answers
Ask our experts a question about this part and we'll get back to you as soon as possible!
1 question answered by our experts.
< Prev
1
Next >
Sort by:
Search filter:
Clear Filter
Your search term must have 3 or more characters.
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
Sorry, we couldn't find any existing answers that matched. Try using some different or simpler keywords, or submit your new question by using the "Ask a Question" button above!
David
February 13, 2022
All lights on the panel light except, start and 4 hr delay, and so it won't start. Is it not latching correctly or something wrong with the panel?
For model number DU945PWSQ0
Hello David, Thank you for your inquiry. If the dishwasher is set for a delayed start and the door is unlatched, the lights will flash and the delay countdown will stop until you latch the door, and it will cause the dishwasher to run at a later time or during off-peak hours. If you have tried pressing cancel/drain to cancel the delay, you may have an issue with either the door latch or the control panel and board. You can test the door latch with a multimeter to see if it is causing the issue. Also check for any loose wiring connections from the control panel to the control board. Good luck with your repair.
Removed spray arm thumb nut. Removed spray arm. replaced worn and broken earings and re-assembled in reverse order. Would have done the repair a lot sooner if I had known that PartsSelect was just a few miles up the highway.
Installed new door seal. Dishwasher still leaked. Googled the model number and then cleaned the filter at the bottom of the dishwasher, still leaked. Verified that manifold bearing was not work. It was OK. Found note that a plugged vent might cause leaking door. Very counterintuitive. Pried off air vent cover. Vent was tho
... Read moreuroughly plugged with calcium deposts from steam. Cleaned these out. Dishwasher no longer leaks.
