Models > DW60M9990AP

DW60M9990AP ((AA)(0000)) Samsung Dishwasher

Jump to:

Find Part by Name

Keep searches simple, eg. "belt" or "pump".
Keep searches simple, eg. "belt" or "pump".
In Stock
Order now and your part arrives by Apr 2
In Stock
Order now and your part arrives by Apr 2
This door guide cap (part number DD67-00113B) is for dishwashers. Follow appropriate safety practices when installing door guide cap DD67-00113B.
In Stock
Order now and your part arrives by Apr 2
On Order
This manufacturer-approved screw is for refrigerators, including Kenmore refrigerator model. Avoid cross-threading refrigerator screw during installation.
In Stock
Order now and your part arrives by Apr 2
SEAL-OIL;DMR78,NBR,BLK,R
In Stock
Order now and your part arrives by Apr 2
In Stock
Order now and your part arrives by Apr 2
$134.28
In Stock
Order now and your part arrives by Apr 2
The drain hose carries drain water from the dishwasher to the drain.
In Stock
Order now and your part arrives by Apr 2
$65.80
This wash vane sensor (part number DD32-00011A) is for dishwashers. Wash vane sensor DD32-00011A monitors the position of the wash vane motor and communicates the position to the electronic control bo...
In Stock
Order now and your part arrives by Apr 2
The drain pump removes the water from the dishwasher tub during the drain phase of the dishwashing cycle. 120V/230
In Stock
Order now and your part arrives by Apr 2

Questions and Answers

We're sorry, but our Q&A experts are temporarily unavailable.
Please check back later if you still haven't found the answer you need.

Common Problems and Symptoms for DW60M9990AP

Viewing 3 of 3
Not cleaning dishes properly
Fixed by these parts
Fixing Fixing
How to fix it
Leaking
Fixed by these parts
Fixing Fixing
How to fix it
Not draining
Fixed by these parts
Fixing
How to fix it
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
Customer:
Mark from kennewick, WA
Parts Used:
DD97-00403E
Difficulty Level:
Difficult
Total Repair Time:
More than 2 hours
Tools:
Pliers, Screw drivers
I replaced the pump assembly with a new drain hose
This is not a repair for the faint of heart. You will have to pretty much disassemble the entire dishwasher to replace the main pump assembly. And it’s not cheap, between the pump assembly and the hose...it was over $300...

This dishwasher is Junk...been through 2 motherboards, plastic internal spray arms...and finally a pump a ssembly...if you own one and the pump begins to leak....shorts the pump motor out....if it gets this far...but a new dishwasher.

As far as partselect...they are 1st rate.
18 of 50 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Customer:
James from Big Spring, TX
Parts Used:
DC62-30314L
Difficulty Level:
Really Easy
Total Repair Time:
30 - 60 mins
Tools:
Pliers, Screw drivers
No water
1) Unplugged unit
2) isolate water supply
3) slide unit out
4) disconnect water hose from dishwasher
5) carefully lay dishwasher on iaccess door.
6) unscrew and open access panel at the bottom
7) unscrew (2) screws attaching supply valve to the dishwasher
8) disconnect water supply hose from supply va lve to using pliers
8) carefully remove valve, connect new valve.
Install supply hose from valve to unit.
Reverse instructions.
1 of 2 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!