Models > NDU2CA-01

NDU2CA-01 Norge Dishwasher

Jump to:

Find Part by Name

Keep searches simple, eg. "belt" or "pump".

Diagrams for NDU2CA-01

Viewing 4 of 4
Keep searches simple, eg. "belt" or "pump".
This screw is well under an inch long, and is made of metal.
In Stock
No Longer Available
$7.28
In Stock
$30.66
Sold Individually.
Special Order
No Longer Available
No Longer Available
$113.94
Special Order
No Longer Available
No Longer Available
No Longer Available
No Longer Available
No Longer Available

Questions and Answers

Be the first to ask our experts a question about this part!

Common Problems and Symptoms for NDU2CA-01

Viewing 1 of 1
Leaking
Fixed by these parts
Fixing
How to fix it
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
Customer:
clarence from ST LOUIS, MO
Parts Used:
Y03000182
Difficulty Level:
Really Easy
Total Repair Time:
1- 2 hours
Tools:
Pliers, Screw drivers
Wouldn"T Drain The Water Completey
Removed the two screws that hold the element in place. I then pulled the element out about 3 inches and disconnected the two wires. . . )
4 of 7 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Customer:
Duane from Seattle, WA
Parts Used:
W10542232
Difficulty Level:
Easy
Total Repair Time:
Less than 15 mins
Tools:
Screw drivers
Two upper rack rollers were broken
Used ascrewdriver to bend the metal rail that the roller rolls on. The part that needed to be bent holds the end cap on. Once bent, the end cap pops off. The the old roller can be removed and the new roller instsalled. The rail then needs to be re-bent.
1 of 2 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Customer:
Jeffrey from Wilson, NC
Parts Used:
W10542232
Difficulty Level:
A Bit Difficult
Total Repair Time:
Less than 15 mins
Tools:
Screw drivers
Upper rack roller cracked then broke
First removed the end cover and clip on the end of the rack slide. Used a flat head screwdriver to push in the clip and carefully pried it out. Then using the same screwdriver, pried up on the rack roller clip attached to the dish rack. Once clip was free of the rack, slid the rack roller off through the front of the slider. Slid the new rack roller into the slider and snapped the roller clip onto the dish rack in the same place the old one was. Carefully twisted the plastic end cover and clip back onto the rack slider. Job complete. The trickest part of the job is removing the rack slider end cover.
1 of 2 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!