Models
>
MDT24P5AST
MDT24P5AST Midea Dishwasher
Jump to:
Find Part by Name
Keep searches simple, eg. "belt" or "pump".
Diagrams for MDT24P5AST
Viewing 1 of 1
Keep searches simple, eg. "belt" or "pump".
$6.55
Good water flow depends on a clean dishwasher filter. The cylinder-shaped part traps food and helps keep debris away from the pump and spray system. If dishes stay dirty, inspect the filter, spray arm...
In Stock
Order now and your part arrives by Oct 16
$17.44
Cracks, hard spots, or torn areas can stop a dishwasher door gasket from sealing well. Food and soap buildup may also leave small gaps that allow water to escape. Clean and inspect the seal before ord...
In Stock
Order now and your part arrives by Oct 16
In Stock
Order now and your part arrives by Oct 16
$17.55
Starting trouble may come from a worn dishwasher door switch. This part checks the door position before the wash cycle begins. A bad switch can also cause the cycle to pause without warning. First cle...
In Stock
Order now and your part arrives by Oct 16
$7.60
Smooth door movement depends on the dishwashers hinge and tension parts. Replace the hinge roller if it is cracked, stuck, or badly worn. A damaged roller may cause the door to feel heavy, crooked, or...
On Order
$22.91
Moisture that remains after a wash cycle can have several causes. The air breather or damper may be damaged, loose, or blocked, but the vent, fan, or heating system may also be at fault. Check these p...
In Stock
Order now and your part arrives by Oct 16
In Stock
Order now and your part arrives by Oct 16
In Stock
Order now and your part arrives by Oct 16
In Stock
Order now and your part arrives by Oct 16
On Order
In Stock
Order now and your part arrives by Oct 16
In Stock
Order now and your part arrives by Oct 16
Common Problems and Symptoms for MDT24P5AST
Viewing 1 of 1
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
- Customer:
- austin from saint marys, GA
- Parts Used:
- 12676000002681
- Difficulty Level:
- Easy
- Total Repair Time:
- Less than 15 mins
Steam was escaping the front, condensing on the door, and dripping down on the floor.
Replaced the door seal. Pulled out the old one and pressed in the new one by hand.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Jim from Virginia Beach, VA
- Parts Used:
- 17476000A02374
- Difficulty Level:
- Easy
- Total Repair Time:
- 30 - 60 mins
- Tools:
- Pliers, Screw drivers
Washer fills then dumps before doing any washing with blue light on front panel and "Rinse" light flashing
turned off Circuit-Breaker to Dishwasher. Removed elec and water inlet and unit from under counter. On table with protection from scratching front, removed bottom panel of washer unit. Removed clamps to short hoses to inlet and output from pump assembly and removed ground and power connector. Replaced "one-time use" clamps with hose clamp
... Read more
s and connected electrical. 20 ~ish minutes. re-installed washer unit under counter and re-connected elec and water input. Turned on Circuit-Breaker. Did not do anything different. Apparently, had low water pressure and when attempted to start at a time when it was obvious the water pressure was better (usually in the evenings/night) washer has worked again flawlessly 4 time now.
Read less
Was this instruction helpful to you?
Thank you for voting!