Models
>
DU110CA-01
DU110CA-01 Magic Chef Dishwasher
Jump to:
Find Part by Name
Keep searches simple, eg. "belt" or "pump".
Diagrams for DU110CA-01
Viewing 4 of 4Keep searches simple, eg. "belt" or "pump".
$7.95
This is a multi-use screw mostly used in dryers. It has a diameter of #10, length of one inch, and thread size of 16. Remember to follow safety practices and instructions provided in the manufacturer ...
In Stock
In Stock
Special Order
In Stock
In Stock
This tub baffle is two inches long. It is all black in color and is made entirely of plastic. This baffle is intended for use with some dishwashers.
No Longer Available
Special Order
Questions and Answers
We're sorry, but our Q&A experts are temporarily unavailable.
Please check back later if you still haven't found the answer you need.
Common Problems and Symptoms for DU110CA-01
Viewing 1 of 1Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
- Customer:
- clarence from ST LOUIS, MO
- Parts Used:
- Y03000182
- Difficulty Level:
- Really Easy
- Total Repair Time:
- 1- 2 hours
- Tools:
- Pliers, Screw drivers
Wouldn"T Drain The Water Completey
Removed the two screws that hold the element in place. I then pulled the element out about 3 inches and disconnected the two wires. . . )
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Duane from Seattle, WA
- Parts Used:
- W10542232
- Difficulty Level:
- Easy
- Total Repair Time:
- Less than 15 mins
- Tools:
- Screw drivers
Two upper rack rollers were broken
Used ascrewdriver to bend the metal rail that the roller rolls on. The part that needed to be bent holds the end cap on. Once bent, the end cap pops off. The the old roller can be removed and the new roller instsalled. The rail then needs to be re-bent.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Jeffrey from Wilson, NC
- Parts Used:
- W10542232
- Difficulty Level:
- A Bit Difficult
- Total Repair Time:
- Less than 15 mins
- Tools:
- Screw drivers
Upper rack roller cracked then broke
First removed the end cover and clip on the end of the rack slide. Used a flat head screwdriver to push in the clip and carefully pried it out. Then using the same screwdriver, pried up on the rack roller clip attached to the dish rack. Once clip was free of the rack, slid the rack roller off through the front of the slider. Slid the
... Read more
new rack roller into the slider and snapped the roller clip onto the dish rack in the same place the old one was. Carefully twisted the plastic end cover and clip back onto the rack slider. Job complete. The trickest part of the job is removing the rack slider end cover.
Read less
Was this instruction helpful to you?
Thank you for voting!