LDT7808BM (00) LG Dishwasher - Instructions

This is apparently a widely known issue for LG, and since their call center was closed due to Coronavirus, I had no luck getting them to cover the repair. Not wanting to wait weeks of months for them to get off their duffs, I ordered the part and unscrewed the six screws holding the control panel on and unplugged the old part, plugged in the new part, and replaced the screws.

Works great now.

Ordered the roller from Parts Select, slid the roller over the little spindle sticking out of the bottom rack and snapped it in place. Job done in less than one minute.

Snapped the rollers on.

Ordered the part after reading your web site about others having the same problem and that the new panel solved the problem. The panel is attached by six easy-to-remove screws. The only difficulty was with the electrical connector. The connector has a release tab you need to depress to disconnect, and the tab is not easily visible as it is on the on the back side as you hold the connector. Once I found the tab, the connector disconnected easily and also connected easily with the new part.

Turn off power to the system - turn breaker off or unplug. Open the door. Remove the six screws at the top. Disconnect the control panel. Connect the new panel. Restore power. Test that buttons work. Replace the screws. Very easy DIY that will save you on calling for repairs. Part came fast, easy to install. 5-10 min tops.

Took off the broken one and snap on the new one.

The parts are wrong and am trying to return them. There was no return information included with delivery. Calling the Customer Service number for assistance did not work.

I would just like to return these rollers and would like a return address.

Thank you!
Penelope

I ordered four wheels to replace the two that were broken and to have two as spares. The wheels are to be snapped onto the bottom of the lower basket. The new wheels broke upon being installed. My extra wheels came in handy. I put them in very hot water for a few minutes to soften the plastic. I put a little Vaseline on the post they were to be attached to. The wheels then slid on and snapped correctly.

Turn off power via breaker, remove 6 screws, unplug old control panel, plug in new panel, put screws back in. Very easy. All screws are accessible with the door open.

Snap off old broken holder . Snap new holders in. No issues.

Saw a YouTube video that explained the problem was the pump. Removed dishwasher from under the counter, flipped it on its side, and unplugged the unit. Removed bottom cover and the pump is right there. Used pliers to lose and move 3 hose clamps. Unplugged 3 wires and unscrewed the ground. Unhooked rubber hold downs and removed. Installed new pump. Parts Select pricing was best I found and shipping was fast. Nice to have a quiet house again when running the dishwasher. Cost in total was less than $100.

snapped on new axel-wheel assembly

Remove the lower dish rack, and remove the filter and screen. Using a screwdriver, remove the 4 screws that attach the bottom wash arm, and lift off. Remove the retaining screw on the rubber boot. Slide the boot off of the square steel tubes (there is a metal clamp around this connection, you may need to use pliers to open it. The clamp mechanism is a simple latch that you have to push apart from the two tabs). Open the clamp that came with the replacement part and examine the mechanism to see how it needs to be oriented to secure it. Slide the new boot on, close and latch the clamp. Replace the retaining screw, then the main bottom wash arm with it's 4 screws, the replace the screen and filter and bottom rack.

These were a simple snap on item. It took longer to carry the parts from the porch that to install. Recently purchased house. Rollers were missing due to overload?? Removed the remaining roller pieces. Cleaned and straightened the axle shafts, spray lubed the tray and snapped the new pieces in place.

Was not able to see where the Stopper, Rollers ( Part # PS3523062) could be attached to the back of the bottom tray, to fix the problem. So the parts were useless.