Models
>
KDFE105PPS0
KDFE105PPS0 KitchenAid Dishwasher
Jump to:
Find Part by Name
Keep searches simple, eg. "belt" or "pump".
Diagrams for KDFE105PPS0
Viewing 2 of 2
Keep searches simple, eg. "belt" or "pump".
In Stock
Order now and your part arrives by May 4
$49.29
This lower door seal is a flexible rubber gasket designed to create a watertight barrier at the bottom of your dishwasher door, preventing leaks, steam, and detergent from escaping during wash cycles....
In Stock
Order now and your part arrives by May 4
In Stock
Order now and your part arrives by May 4
In Stock
Order now and your part arrives by May 4
In Stock
Order now and your part arrives by May 4
In Stock
Order now and your part arrives by May 4
In Stock
Order now and your part arrives by May 4
In Stock
Order now and your part arrives by May 4
In Stock
Order now and your part arrives by May 4
$21.82
This screw provides secure fastening for components, helping maintain proper alignment and structural stability during operation. Correct fastening reduces vibration, prevents component movement, and ...
In Stock
Order now and your part arrives by May 4
$79.63
This seal helps create a tight barrier to maintain proper temperature and prevent heat loss during appliance operation. Replacing a worn or damaged seal can improve efficiency and support consistent p...
In Stock
Order now and your part arrives by May 4
In Stock
Order now and your part arrives by May 4
Common Problems and Symptoms for KDFE105PPS0
Viewing 4 of 4Leaking
Fixed by these parts
How to fix it
Door latch failure
Fixed by these parts
How to fix it
Will not dispense detergent
Fixed by these parts
How to fix it
Not drying dishes properly
Fixed by these parts
How to fix it
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
- Customer:
- Joseph from Sterling Heights, MI
- Parts Used:
- W11551775
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
Warranty Service lost the two screws that held the cover below the door in place
It’s great when you have parts that fit and a schematic to go by. I got both from this site. There are three parts that these screws hold in place. Use the schematic to see which way each part is facing. Line all the parts up and then look through the covers. You’ll see pre drilled holes on either side of the cover. Line the screws up to
... Read more
the pre drilled holes. Put the first screw in half way then insert the second screw all the way. Come back to the first screw and tighten it all the way. Two screws, two minutes and I was done. Real easy repair, just awkward as you are on your belly on the floor. I used a drill with a socket that fit the screw head.
Read less
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Kathryn from Carol Stream, IL
- Parts Used:
- WPW10348409
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
- Tools:
- Screw drivers
Screws on the door of the dishwasher were very loose.
Went to PartsSelect. Put in Dishwasher model number. Chose the screws for that model number. Ordered the screws. Can't get any easier than that!
Was this instruction helpful to you?
Thank you for voting!