Models > DW860UQW

DW860UQW Jenn-Air Dishwasher

Jump to:

Find Part by Name

Keep searches simple, eg. "belt" or "pump".

Diagrams for DW860UQW

Viewing 6 of 6
Keep searches simple, eg. "belt" or "pump".
This is a genuine OEM replacement silverware basket for your dishwasher. It is gray in color and comes as an assembly with a hinged cover and a handle. The basket sits in the front of the bottom rack ...
In Stock
Order within the next 6 hrs and your part ships today!
This door gasket can be installed by simply pressing it into the channel around the door. This dishwasher door gasket, or door seal, allows the dishwasher door to have an airtight seal when closing th...
In Stock
Order within the next 6 hrs and your part ships today!
This upper dishwasher dishrack roller is just over an inch in diameter. It is all white in color and is made entirely of plastic.
In Stock
Order within the next 6 hrs and your part ships today!
$11.80
This hose clamp extends from half an inch to an inch in diameter. It is made entirely of metal and is intended for use with Maytag brand washing machines.
In Stock
Order within the next 6 hrs and your part ships today!
This part senses when the door is closed so the cycle can start.
In Stock
Order within the next 6 hrs and your part ships today!
This wheel attaches to the inside of the tub to help guide the track and support the top rack.
In Stock
Order within the next 6 hrs and your part ships today!
This part is used to house the lower spray arm.
In Stock
Order within the next 6 hrs and your part ships today!
This dispenser door retaining pin is less than one inch long. Sold individually.
In Stock
Order within the next 6 hrs and your part ships today!
$8.04
Sold individually. Lock washers are used with screws when vibration from an appliance may cause the screw to loosen. Lock washers are also used in the electrical components of an appliance to ensure ...
Special Order
$10.63
Sold individually. This part is exactly 1 inch long.
In Stock
Order within the next 6 hrs and your part ships today!
This grommet for your soap dispenser door is just under an inch long.
In Stock
Order within the next 6 hrs and your part ships today!
This wax motor is a little over two inches long. It is the rinse and detergent activator for some dishwashers.
In Stock
Order within the next 6 hrs and your part ships today!

Questions and Answers

We're sorry, but our Q&A experts are temporarily unavailable.
Please check back later if you still haven't found the answer you need.

Common Problems and Symptoms for DW860UQW

Viewing 11 of 11
Leaking
Fixed by these parts
Fixing Fixing Fixing
How to fix it
Will not dispense detergent
Fixed by these parts
Fixing Fixing Fixing
How to fix it
Door latch failure
Fixed by these parts
Fixing Fixing Fixing
How to fix it
Not cleaning dishes properly
Fixed by these parts
Fixing Fixing Fixing
How to fix it
Will Not Start
Fixed by these parts
Fixing Fixing Fixing
How to fix it
Will not fill with water
Fixed by these parts
Fixing Fixing
How to fix it
Not draining
Fixed by these parts
Fixing Fixing
How to fix it
Noisy
Fixed by these parts
Fixing Fixing Fixing
How to fix it
Not drying dishes properly
Fixed by these parts
Fixing
How to fix it
Lid or door won’t close
Fixed by these parts
Fixing Fixing
How to fix it
Door won’t close
Fixed by these parts
Fixing
How to fix it
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
Customer:
Tim from Ringgold, GA
Parts Used:
WP99001553, WP902894
Difficulty Level:
Easy
Total Repair Time:
30 - 60 mins
Tools:
Nutdriver
Water dripping from right corner of door
Took out about 7 torx screws to remove the inner door liner. Discovered evidence of leak coming from the sop dispenser latch, and noticed the grommet had turned soft and was torn. The grommet is only about 1" square. Used nut driver to remove two screws to remove latch assembly. Slipped old grommet off and put new one on, and reattached t he latch. The foam seal at the bottom of the door looked worn, so we replaced it with weatherstripping from home improvement store. The main door seal was brittle, so we replaced it too - just grab an end and pull the old one out. The new one was installed by starting at one end and we just pushed it in place. We used a nut-driver to push it in - we were afraid a screwdriver might damage it. The new door seal required us to latch the door to get it to stay closed the fist couple of days, but now it has loosened up a bit and works as expected. And NO MORE LEAKS. Cost is much less than a new unit!
599 of 613 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Customer:
Cheryl from South Burlington, VT
Parts Used:
WP6-918873, 99002571
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins
bottom rack needed replacing
Just took it out of the box and slid it in.
Only problem I encountered, and I think it was due to the age of the dishwasher, was the newunit was not as deep as teh original rack. This will require a new method of loading dishes. Also, the new basket doesn't really fit well in the new rack.
Still cheaper than replacing a good cle aning dishwasher!
527 of 549 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Customer:
Kathy from Lombard, IL
Parts Used:
WP903093
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins
Tools:
Pliers
Rack roller broke
I opened the end stop of the rack, replaced the roller, and put the end stop back on. I can't believe I paid the repairman the last time $125????? An he put in a regular screw that rusted and broke the roller. Took me 3 minutes! Thanks
497 of 502 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!