Models
>
GSS1800H00WW
GSS1800H00WW General Electric Dishwasher
Jump to:
Find Part by Name
Keep searches simple, eg. "belt" or "pump".
Diagrams for GSS1800H00WW
Viewing 3 of 3
Keep searches simple, eg. "belt" or "pump".
It provides a seal between the tub and the door to prevent water from leaking.
No Longer Available
This water inlet valve should be located behind the lower kickplate panel in either the right or left corner. The attaching solenoids on the valve open and close according to the desired amount of water needed.
No Longer Available
Special Order
Special Order
Special Order
Special Order
Special Order
Special Order
Special Order
Questions and Answers
We're sorry, but our Q&A experts are temporarily unavailable.
Please check back later if you still haven't found the answer you need.
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
- Customer:
- Andrew from Jay, VT
- Parts Used:
- WD13X10051
- Difficulty Level:
- Easy
- Total Repair Time:
- 15 - 30 mins
- Tools:
- Screw drivers
broken door latch
Removed the top face plate, approx 7 Phillips screws,however, the latch mechanism is held by 2 Torx screws, the 4 electrical spade connectors were not that easy to pull off, but connected easily to the new part.
Ordered a Black latch, received a white one!
Oh well, it's easy to see it.
Checked the existing gasket, servicabl ... Read more e, so kept the new one in reserve.
MYSTERY, the one & only paper in the package referred to a slinger washer install on a fan motor for a REFRIGERATOR!!
instruction sheet # 5303950152 Rev 8/01
Go figure!
Ordered a Black latch, received a white one!
Oh well, it's easy to see it.
Checked the existing gasket, servicabl ... Read more e, so kept the new one in reserve.
MYSTERY, the one & only paper in the package referred to a slinger washer install on a fan motor for a REFRIGERATOR!!
instruction sheet # 5303950152 Rev 8/01
Go figure!
Read less
Was this instruction helpful to you?
Thank you for voting!