GLDA696P02SS General Electric Dishwasher - Instructions
Jump to:
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
- Customer:
- Christina from Canton, GA
- Parts Used:
- WD12X10231
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
Wheels had come off and were broken
We ordered a whole new set for the lower rack and even though they were smaller than the original ones, we replaced them all and now the rack slides in and out of the dishwasher with ease!
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- David from MILLBRAE, CA
- Parts Used:
- WD08X10062
- Difficulty Level:
- Difficult
- Total Repair Time:
- More than 2 hours
- Tools:
- Pliers, Screw drivers
Bottom door gasket loose on one side preventing door from closing completely.
Pulled dishwasher partly out from cabinet. Removed door after disconnecting springs. Removed old gasket easily. The new gasket was the correct part but would not slip into the place of the original. The door sheet metal was crimped onto the original gasket at the factory with some kind of tool to hold it securely. Had to spread the sheet metal with a screwdriver to get the new gasket in place and used silicone seal to keep in position. Re-assembled the door after the silicone seal was dry and replaced dishwasher into the cabinet. So far it is working fine! Overall this gasket was not easy to change.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Michael from Glen Allen, VA
- Parts Used:
- WD01X10306, WD01X10305, WD08X23648
- Difficulty Level:
- Easy
- Total Repair Time:
- 30 - 60 mins
- Tools:
- Screw drivers
Leaking from the rear of the appliance
I pulled the dishwasher out, and discovered that the translucent pipe leading up the back of the machine was leaking at the point at which it fed into the middle tray.
I
I
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- STEPHANIE from NEW YORK, NY
- Parts Used:
- WD12X10231
- Difficulty Level:
- Very Easy
- Total Repair Time:
- Less than 15 mins
Broken wheels on lower rack
A couple of lower rack wheels had fallen off, making it extremely difficult to roll the rack in and out. Putting on the new wheels was just a matter of popping them on and giving a sturdy push until they "clicked." Everything works perfectly now.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Calvin from VISALIA, CA
- Parts Used:
- WD12X10231
- Difficulty Level:
- Very Easy
- Total Repair Time:
- Less than 15 mins
Broken lower rack wheels
Remove and replace broken wheels by hand, simple.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Joseph from Columbia, MD
- Parts Used:
- WD12X10231
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
added replacement wheels to lower rack
put them on
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- RAYMOND from KENILWORTH, NJ
- Parts Used:
- WD03X10031
- Difficulty Level:
- Very Easy
- Total Repair Time:
- Less than 15 mins
- Tools:
- Pliers, Screw drivers
Door falling down
Remove the 2 mounting screws holding the dishwasher to the counter top. Pull forwards a few inches.. make sure you have slack for power and water. Attach bottom of spring and with a pair of pliers stretch the spring and attach to top.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Belinda from Briarwood, NY
- Parts Used:
- WD12X10231
- Difficulty Level:
- Easy
- Total Repair Time:
- Less than 15 mins
no part number and incorrect info from manufacturer
the repair was not the issue: finding the proper part was. the part listed by Frigidaire is not correct but with the help of your phone service associates and the east to navigate web site, I was able to locate the parts. thank you for everything....all in all, the experience was a good one.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Thomas from Cayucos, CA
- Parts Used:
- WD12X10231
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
Broken stud on original equipment whee,
Popped the old ones off and inserted the new ones. Though they are smaller the stud is fixed and not likely to separate.Works like a charm.Would shop here again
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Jose from HOUSTON, TX
- Parts Used:
- WD12X10231
- Difficulty Level:
- Really Easy
- Total Repair Time:
- 15 - 30 mins
- Tools:
- Pliers
Roller wheels on lower dish basket were worn and broken
Removed old roller with pilers and pop in New roller really easy very happy partselect had right rollers it made it easy
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- thomas from TINLEY PARK, IL
- Parts Used:
- WD12X10231
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
Wheels broken
Just popped the old wheels off with small tack hammer very easy to get off and pop back on in a couple minutes..
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Rosalie from GRAHAM, WA
- Parts Used:
- WD22X10050
- Difficulty Level:
- Very Easy
- Total Repair Time:
- Less than 15 mins
Gasket wore out and the spray arm fell off
Snapped on new spray arm...in less than 5 minutes.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Carol from WALSENBURG, CO
- Parts Used:
- WD12X10231
- Difficulty Level:
- Easy
- Total Repair Time:
- Less than 15 mins
two wheels broke off
knocked the broken piece off and snapped the new wheels on - easy breezy.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Sophie from HOLYOKE, MA
- Parts Used:
- WD12X10286
- Difficulty Level:
- Very Easy
- Total Repair Time:
- Less than 15 mins
Replaced the micro filter
Just tool out the old micro filter and put in the new filter.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Fay from Highland, CA
- Parts Used:
- WD28X10197
- Difficulty Level:
- A Bit Difficult
- Total Repair Time:
- 15 - 30 mins
Holes in middle silverware basket
Unsnapped the old middle basket, but then still having difficulty getting one side of the old basket to fit in the grooves on the new middle basket. Have tried it several ways, but still just does not seem to be the right fit on that one side.
Was this instruction helpful to you?
Thank you for voting!