The wheels on the racks in your dishwasher allow it to smoothly pull in and out of the appliance. If a wheel becomes broken or damaged due to regular wear or excessive force, it should be replaced so ...
This guide rail bracket assembly, also known as the dishrack support roller, is made for your dishwasher. It connects to the tub, and allows the dishrack guide rail to move in and out. If the wheels o...
This part is the replacement tub gasket for your dishwasher. It is black in color and is made of rubber. The tub gasket fits around the circumference of your dishwasher tub, and creates a seal that pr...
This door spring is approximately 7 inches long. The dishwasher door spring applies tension to the dishwasher door through the door hinge to prevent the door from dropping too quickly when the unit i...
This is a replacement upper spray arm with gasket for your dishwasher. The spray arm is made of gray plastic and is approximately 16.5 inches in length. The gasket is black in color and is approximate...
This is an official OEM approved replacement part for many GE Dishwashers, to see if this part will fit your appliance please see the "Model Cross Reference List" below. The Ring Nut with Gasket conne...
Ask our experts a question about this part and we'll get back to you as soon as possible!
1 question answered by our experts.
< Prev
1
Next >
Sort by:
Search filter:
Clear Filter
Your search term must have 3 or more characters.
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
Sorry, we couldn't find any existing answers that matched. Try using some different or simpler keywords, or submit your new question by using the "Ask a Question" button above!
Larry
July 10, 2023
The appliance was not used for 4 months. Now it had a small water leak. Then it stopped filling with water. When started, it goes through up start up cycle then it stops. I noticed that no water enters the system
For model number GHDA696P02SS
Hello Larry, Thank you for the question. We suggest testing the Water Inlet Valve. Use your multitester to test the valve for continuity. Set the device to the ohms setting x 1. Touch each of the meter's probes to a terminal. If you receive a reading of infinity, it means the valve's solenoid is faulty and the valve needs to be replaced. If your valve has two solenoids (four terminals), test the second pair of terminals in the same manner. If either pair of terminals receives a result of infinity, replace the water inlet valve. We hope this helps!
We ordered a whole new set for the lower rack and even though they were smaller than the original ones, we replaced them all and now the rack slides in and out of the dishwasher with ease!
Pulled dishwasher partly out from cabinet. Removed door after disconnecting springs. Removed old gasket easily. The new gasket was the correct part but would not slip into the place of the original. The door sheet metal was crimped onto the original gasket at the factory with some kind of tool to hold it securely. Had to spread the s
... Read moreheet metal with a screwdriver to get the new gasket in place and used silicone seal to keep in position. Re-assembled the door after the silicone seal was dry and replaced dishwasher into the cabinet. So far it is working fine! Overall this gasket was not easy to change.
