GPT225SGL2BB General Electric Dishwasher - Instructions
Jump to:
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
- Customer:
- Derek from MOUNT HOREB, WI
- Parts Used:
- WD15X30838
- Difficulty Level:
- Easy
- Total Repair Time:
- 15 - 30 mins
- Tools:
- Screw drivers
Replace the filler/drain hose on a portable dishwasher
I followed a YouTube video except I didn’t take the cabinet off. It wasn’t hard to feed the hose through. Only needed a Philips screwdriver. GE needs a more durable faucet connection because that is the part that fails within 2 years.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Vanessa from San Antonio, TX
- Parts Used:
- WD22X24672, WD08X24750
- Difficulty Level:
- Very Easy
- Total Repair Time:
- Less than 15 mins
Water leak at bottom of door during cycles
Tub gasket was not the issue, the lower spray arm corrected the fix! Took under two mins to pop off and replace and all was fixed. Very thankful for this site!
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Kenneth from PROSPER, TX
- Parts Used:
- WD22X24672
- Difficulty Level:
- Very Easy
- Total Repair Time:
- Less than 15 mins
Leaking from door
Gasket was verified to be good but found the lower spray arm cracked causing water to spray directly at door and leak out front of unit. Replaced arm and problem solved
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Al from REDDING, CA
- Parts Used:
- WD01X24739, WD01X24738
- Difficulty Level:
- Really Easy
- Total Repair Time:
- 15 - 30 mins
- Tools:
- Screw drivers
While the dishwasher door was fully open, someone accidentally turned and tripped over it with much of their weight. Now the door won't fully close.
*UNPLUG THE DISHWASHER
*remove 2 mounting screws attatching dishwasher to underside of countertop.
*with the dishwasher door closed, remove left and right side hinge cables off pulley and hinge.
*fully open door and remove all perimeter screws except for 2 screws holding the latch assembly.
*carefully separate outer door shell from door body.
*disconnect electrical clip from inside top of outer shell. Carefully set outer shell aside.
*each hinge has 2 Torx head screws and 2 Phillips head screws, remove these. You can now slide the door body out and away from the hinges and dishwasher.
*these hinges were slightly bent so I had to use a ball peen hammer to tap them off the post.
To reassemble, reverse these instructions.
*remove 2 mounting screws attatching dishwasher to underside of countertop.
*with the dishwasher door closed, remove left and right side hinge cables off pulley and hinge.
*fully open door and remove all perimeter screws except for 2 screws holding the latch assembly.
*carefully separate outer door shell from door body.
*disconnect electrical clip from inside top of outer shell. Carefully set outer shell aside.
*each hinge has 2 Torx head screws and 2 Phillips head screws, remove these. You can now slide the door body out and away from the hinges and dishwasher.
*these hinges were slightly bent so I had to use a ball peen hammer to tap them off the post.
To reassemble, reverse these instructions.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Richard from SEELEY LAKE, MT
- Parts Used:
- WD22X25158
- Difficulty Level:
- Very Easy
- Total Repair Time:
- Less than 15 mins
Upper basket sprayer was falling off under pressure.
Replaced the sprayer with new. Very easy repair.
Was this instruction helpful to you?
Thank you for voting!