GSM1800N00BB General Electric Dishwasher - Instructions
Jump to:
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
- Customer:
- Dean from Newark, NY
- Parts Used:
- WD12X10174, WD01X10207
- Difficulty Level:
- Really Easy
- Total Repair Time:
- 15 - 30 mins
- Tools:
- Screw drivers
soap dispenser latch was worn - cover would not stay shut
remove door panel (outer side) remove wires from soap dispenser remove old dispenser install new dispenser re-install wires and door cover total time less than 30 minutes
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Pauline from Oceanside, CA
- Parts Used:
- WD28X10215
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
Silverware basket had holes in it.
Took old one out and replaced new one in less than one minute.
Very easy and easy to order also.
Very easy and easy to order also.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- George from Gregory, MI
- Parts Used:
- WD28X10215
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
Bottom of basket deteriorated
Remove old basket, discard, place new basket in dishwasher, fill with dirty silverware, run wash cycle.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Andre from Ventura, CA
- Parts Used:
- WD28X10215, WD01X10242
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
Dishwasher didn't clean well. Silverware basket was damaged.
Just removed the old ring nut by hand and replaced it with the new one. Took me one minute.
Exchanged the silverware basket.
Exchanged the silverware basket.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Duane from Springfield, MO
- Parts Used:
- WD01X10242
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
top washer arm performing poorly
removed top rack which contains washer arm.
unscrewed the old ringnut which had lost its gasket, that the top rack washer arm merges with.
screwed the new ring nut onto the threads of the pipe which protrudes thru the back inside if the machine. reinstalled the top rack .
job done.
unscrewed the old ringnut which had lost its gasket, that the top rack washer arm merges with.
screwed the new ring nut onto the threads of the pipe which protrudes thru the back inside if the machine. reinstalled the top rack .
job done.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Tom from Brooklyn, NY
- Parts Used:
- WD01X10242, WD08X23648
- Difficulty Level:
- Easy
- Total Repair Time:
- 30 - 60 mins
- Tools:
- Screw drivers, Wrench (Adjustable)
Leaking from top of main conduit
Note: I also purchased the main conduit part (PartSelect #: PS958967).
My repair is pretty much the same as the previous poster from TX. The RING NUT W/GASKET part seems to wear easily on this GE dishwasher.
Disconnected dishwasher from electrical. You have to remove the rear lower brace panel in order to remove the main conduit. The bottom end of the main conduit is clamped to a hose.
Installed the new main conduit and o-ring, screwed RING NUT W/GASKET onto upper end of main conduit. I tightened the ring nut with the wrench to make sure I got a good seal without over tightening.
I had to use a new hose clamp to reattach the lower end of the main conduit.
Reinstalled brace panel, reconnected electric, and tested.
It was an easy fix, the parts did not cost too much. I'm glad I fixed it rather than paying some repairman $$. I purchased an extra RING NUT W/GASKET in case it deteriorates again.
My repair is pretty much the same as the previous poster from TX. The RING NUT W/GASKET part seems to wear easily on this GE dishwasher.
Disconnected dishwasher from electrical. You have to remove the rear lower brace panel in order to remove the main conduit. The bottom end of the main conduit is clamped to a hose.
Installed the new main conduit and o-ring, screwed RING NUT W/GASKET onto upper end of main conduit. I tightened the ring nut with the wrench to make sure I got a good seal without over tightening.
I had to use a new hose clamp to reattach the lower end of the main conduit.
Reinstalled brace panel, reconnected electric, and tested.
It was an easy fix, the parts did not cost too much. I'm glad I fixed it rather than paying some repairman $$. I purchased an extra RING NUT W/GASKET in case it deteriorates again.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Deborah from Los Osos, CA
- Parts Used:
- WD28X10215
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
holes in dishwasher silverware basket
removed old basket, put new one in
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- ANDY from SHELBY, OH
- Parts Used:
- WD12X10164, WD01X10242, WD08X23648
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
- Tools:
- Pliers, Screw drivers, Wrench set
Water Leak
Replaced main conduit, o ring,and ring nut with gasket.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- John from ANN ARBOR, MI
- Parts Used:
- WD28X10215
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
The basket handle was broken in transit.
I ordered the silverware basket because the original started to separate. The shipment box was damaged and sure enough the handle was broken. The handle can be removed so I replaced the new handle with the old handle, since it was the basket that really needed. Pops off very easily.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- john from TORONTO, OH
- Parts Used:
- WD31X10074
- Difficulty Level:
- Easy
- Total Repair Time:
- 30 - 60 mins
- Tools:
- Pliers, Screw drivers, Wrench set
door gasket bad, door deformed
removed inner panel, removed soap dispenser installtion was straight forward 45 min time install
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- CAROL from BUFFALO, NY
- Parts Used:
- WD28X10215
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
needed new silverware basket
took out the old basket and put in the new basket
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Garry from Cleburne, TX
- Parts Used:
- WD12X10164, WD01X10242, WD08X23648
- Difficulty Level:
- Really Easy
- Total Repair Time:
- 30 - 60 mins
- Tools:
- Pliers, Screw drivers
Upper water conduit broke, flooding kitchen
Pulled dishwasher, disconnected electrical, removed rear lower brace panel to access lower clamp. Replaced conduit with new o-ring, nut, and lower clamp. Reinstalled brace panel, reconnected electrical, reinstalled dishwasher, and tested.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- dianne from monacka, PA
- Parts Used:
- WD12X10164, WD01X10242, WD08X23648
- Difficulty Level:
- Easy
- Total Repair Time:
- 15 - 30 mins
- Tools:
- Pliers, Screw drivers
the threads on the conduit broke and caused a leak
I pulled the dishwasher out and turned it on found the problem. I took the part off to find it broken. ordered the part on a sunday afternoon and it was there on Wednesday in time to fix it before I had to fly home.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Larry from Long Island City, NY
- Parts Used:
- WD22X10039
- Difficulty Level:
- Easy
- Total Repair Time:
- 15 - 30 mins
Chinese made Upper spray arm tabs broke
Installed new plastic arm and it kept falling off so I super glued it to the upper attachment.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- John from Frederick, MD
- Parts Used:
- WD12X10164, WD08X10048, WD01X10242, WD08X23648
- Difficulty Level:
- A Bit Difficult
- Total Repair Time:
- More than 2 hours
- Tools:
- Screw drivers, Wrench (Adjustable)
Water gushed from the main conduit. Dishwasher is not 2 years old.
First the parts took forever to get here and then the new main conduit nut was defective just as the original from the factory was. It would not thread correctly and had to be wet then forced by hand until the skin ripped off my fingertips.
GE stands for "Good Enough"
GE stands for "Good Enough"
Was this instruction helpful to you?
Thank you for voting!