Models
>
FDB2410HIS3B
FDB2410HIS3B Frigidaire Dishwasher
Jump to:
Find Part by Name
Keep searches simple, eg. "belt" or "pump".
Diagrams for FDB2410HIS3B
Viewing 4 of 4Manuals & Guides for FDB2410HIS3B
Click to downloadKeep searches simple, eg. "belt" or "pump".
$36.10
checked on ERP and this is the complete silverware basket and not just the small side piece
In Stock
Order within the next 3 mins and your part ships today!
In Stock
Order within the next 3 mins and your part ships today!
Special Order
On Order
In Stock
Order within the next 3 mins and your part ships today!
Special Order
In Stock
Order within the next 3 mins and your part ships today!
Questions and Answers
We're sorry, but our Q&A experts are temporarily unavailable.
Please check back later if you still haven't found the answer you need.
Common Problems and Symptoms for FDB2410HIS3B
Viewing 6 of 6Door latch failure
Fixed by these parts
How to fix it
Leaking
Fixed by these parts
How to fix it
Not cleaning dishes properly
Fixed by these parts
How to fix it
Door won’t close
Fixed by these parts
How to fix it
Will Not Start
Fixed by these parts
How to fix it
Will not fill with water
Fixed by these parts
How to fix it
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
- Customer:
- Daniel from Cutchogue, NY
- Parts Used:
- 5304535183
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
broken latch
removed front face of dishwasher removed 2 screws holding latch and removed 2 push in plugs reinstalled the same.
job completed in less than 15 min.
job completed in less than 15 min.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Paul from Belmont, CA
- Parts Used:
- 5304482406
- Difficulty Level:
- A Bit Difficult
- Total Repair Time:
- 30 - 60 mins
- Tools:
- Nutdriver, Screw drivers, Wrench (Adjustable), Wrench set
Water leaking out onto floor when not in use!
Remove front Fascia on floor, use AC sniffer find hot wires into unit. Flip circuit breaker at panel. Verify no AC, shut water valve off on Dishwasher supply. Disconnect two valve wires to solenoid. Use wrench set to find proper size and use to remove supply line. Unscrew two Phillips sheet metal screws that hold valve support bracket and
... Read more
remove bracket with it now being held in by water inlet valve hose to interior wall of Dishwasher. Use Tin Snips to cut off metal band securing hose to old water inlet valve. Place new valve onto inlet hose, secure with new hose clamp (you must supply) tighten hex nut on clamp till water tight. Fasten wires onto the solenoid and mount assembly support bracket to dishwasher. Now connect water supply line after wrapping threads with pipe dope tape fasten and secure nut with adjustable wrench till water tight open supply valve and look for leaks with a flash light. If no leaks, reset breaker and test run and drain. No leaks replace fascia and have a Beer great Job saved $850 min. on a new dishwasher!
Read less
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- William from Clarkfork, ID
- Parts Used:
- 5304535183
- Difficulty Level:
- Easy
- Total Repair Time:
- 30 - 60 mins
- Tools:
- Screw drivers
door would not lock
replaca latch as you mentioned
Was this instruction helpful to you?
Thank you for voting!