Models > EIDW6105GS1A

EIDW6105GS1A Electrolux Dishwasher

Jump to:

Find Part by Name

Keep searches simple, eg. "belt" or "pump".

Diagrams for EIDW6105GS1A

Viewing 8 of 8

Manuals & Guides for EIDW6105GS1A

Click to download
Keep searches simple, eg. "belt" or "pump".
Upper Rack Assembly - T3 PRO. This is the complete upper rack and the wash arm.
In Stock
Sold individually.
In Stock
This part releases the detergent and rinse aid into the dishwasher. NOTE: Color may vary but the part will function the same as the original.
In Stock
In Stock
In Stock
No Longer Available
No Longer Available
Sold individually.
In Stock
In Stock
No Longer Available
Sold individually.
In Stock
Special Order

Questions and Answers

We're sorry, but our Q&A experts are temporarily unavailable.
Please check back later if you still haven't found the answer you need.

Common Problems and Symptoms for EIDW6105GS1A

Viewing 9 of 9
Not cleaning dishes properly
Fixed by these parts
Fixing Fixing Fixing
How to fix it
Leaking
Fixed by these parts
Fixing Fixing Fixing
How to fix it
Will not dispense detergent
Fixed by these parts
Fixing
How to fix it
Door latch failure
Fixed by these parts
Fixing
How to fix it
Not draining
Fixed by these parts
Fixing Fixing
How to fix it
Will Not Start
Fixed by these parts
Fixing
How to fix it
Will not fill with water
Fixed by these parts
Fixing
How to fix it
Door won’t close
Fixed by these parts
Fixing
How to fix it
Not drying dishes properly
Fixed by these parts
Fixing
How to fix it
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
Customer:
C from Covina, CA
Parts Used:
5304507354
Difficulty Level:
Easy
Total Repair Time:
15 - 30 mins
Tools:
Screw drivers
Dispenser door broken.
Disconnect from power
Unscrewed 4 phillips screws from top of outer door.
Unscrewed 2 screws each siide of door.
Lower outer door section drops away.
Note wiring sequence on dispenser, then disconnect wires.
Unscrew 6 screws on dispenser and lift dispenser out.

Place new dispenser in place (note orient ation), ann fasten in place with screws, remembering to replace wire retainer on left lower screw.
Reconnect wires to dispenser correctly.
Slide lower outer door over tabs and secure with the 4 side screws.
Ensure lower door is up under control panel and secure with the 4 top screws.

Fill dispenser with detergent, reconnect power and test run while enjoying a cup of tea in celebration of a job well done..
56 of 67 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Customer:
Keith from Coventry, RI
Parts Used:
A01986801
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins
Center spray arm broke
I was able to pull out the top basket were the glasses are put then I lined up the back and the center plastic clip an slid on the center spray arm. It took about 2 miniutes
41 of 90 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Customer:
Justin from Miami, FL
Parts Used:
5304507354
Difficulty Level:
Easy
Total Repair Time:
15 - 30 mins
Tools:
Screw drivers
Broken door on dispenser
The only difficultpart was to figure out how to remove the stainless cover from the door. Seems it slides upwards after screws are removed. After that it is self explainatory and goes back together in 5 minutes.
14 of 21 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!