Models > EIDW5905JS0A > Instructions

EIDW5905JS0A Electrolux Dishwasher - Instructions

Jump to:

All Instructions for the EIDW5905JS0A
1 - 15 of 44
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
Customer:
C from Covina, CA
Parts Used:
5304507354
Difficulty Level:
Easy
Total Repair Time:
15 - 30 mins
Tools:
Screw drivers
Dispenser door broken.
Disconnect from power
Unscrewed 4 phillips screws from top of outer door.
Unscrewed 2 screws each siide of door.
Lower outer door section drops away.
Note wiring sequence on dispenser, then disconnect wires.
Unscrew 6 screws on dispenser and lift dispenser out.

Place new dispenser in place (note orientation), ann fasten in place with screws, remembering to replace wire retainer on left lower screw.
Reconnect wires to dispenser correctly.
Slide lower outer door over tabs and secure with the 4 side screws.
Ensure lower door is up under control panel and secure with the 4 top screws.

Fill dispenser with detergent, reconnect power and test run while enjoying a cup of tea in celebration of a job well done..
56 of 67 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Customer:
Lauren from Peabody, MA
Parts Used:
5304535382
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins
large holes in the bottom of the basket where pieces of plastic kept breaking off
I replaced the basket. No tools necessary. New basket seems sturdier than original. Very satisfied with my purchase.
18 of 21 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Customer:
Keith from Coventry, RI
Parts Used:
A01986801
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins
Center spray arm broke
I was able to pull out the top basket were the glasses are put then I lined up the back and the center plastic clip an slid on the center spray arm. It took about 2 miniutes
40 of 89 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Customer:
Alan from Holley, NY
Parts Used:
5304535382
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins
silverware basket skunked
tossed the old one a replaced with a new.Hardest 10 second repair ever....It took 10 seconds had to open and close the door.
13 of 14 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Customer:
Craig from Marlborough, MA
Parts Used:
5304535382
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins
busted center portion of silverware basket
New one snaps into place easily.
19 of 33 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Customer:
Michael from Katy, TX
Parts Used:
5304534829
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins
Fence in dishwasher rack rusted
Unsnapped three clips in lower rack securing old fence in rack. Attached clips to new fence and snapped assembly back into rack.
15 of 21 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Customer:
Justin from Miami, FL
Parts Used:
5304507354
Difficulty Level:
Easy
Total Repair Time:
15 - 30 mins
Tools:
Screw drivers
Broken door on dispenser
The only difficultpart was to figure out how to remove the stainless cover from the door. Seems it slides upwards after screws are removed. After that it is self explainatory and goes back together in 5 minutes.
14 of 21 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Customer:
Ernest from POWELL, WY
Parts Used:
5304535250
Difficulty Level:
Easy
Total Repair Time:
15 - 30 mins
Tools:
Screw drivers
Portions of the rack had the coating wear off, exposing the metal, which began to rust.
Removing the old rack was accomplished by removing the grey retainer clips located at the end of the silver rack guides. This allows the entire upper rack to slide out of the guide tracks. Unless you purchased all of the additional parts associated with the rack you must remove the needed old parts such as the spray arm, plate guides, wheel assemblies, etc. to complete the replacement and reassembly. Each of these pieces are "snapped on" by clips that are removed with moderate difficulty. Mostly due to the apprehension that you are going to break them, however, with only the pressure exerted by your fingers they will snap off and will go actually go back on easier. The order you remove and replace the various parts is your choice. The exact positioning of the parts back on the new rack is critical, so if your memory is not good, take a quick photo with your cell phone for reference. The only tool I used was a small screwdriver to separate the clip when I first removed the rack, but in retrospect I could have removed it by hand. The key thing to remember is do not apply excess force when trying to remove the old parts, just direct pressure with your fingers. Good luck, it took me only about 15 minutes from start to finish. The best part is I probably saved $150.00 by doing it myself, figuring service time for a repairman, plus his mark-up on the parts.
11 of 13 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Customer:
tom from PASADENA, MD
Parts Used:
A01986801
Difficulty Level:
Very Easy
Total Repair Time:
Less than 15 mins
Top spray bar rear gasket failed
Replaced the entire top rack with spray bar.
12 of 20 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Customer:
Deb from MARIA STEIN, OH
Parts Used:
5304535253, 5304506535, 154740304
Difficulty Level:
Very Easy
Total Repair Time:
Less than 15 mins
Needed to replace some racks that were rusted and coming apart
All we had to do was remove the old racks and pop in the new. Very easy to do!
6 of 7 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Customer:
Lori from IRMO, SC
Parts Used:
5304507354
Difficulty Level:
Easy
Total Repair Time:
30 - 60 mins
Tools:
Nutdriver, Pliers
Detergent Dispenser didn't work..
After turning of the power to dishwasher, I opened the door took of the two bottom screws on both sides of door. Closed the door and front panel just slide off. Then I took a picture of the dispenser to make use I could figure out how to put the wiring back together. Removed the six screws holding it in place and popped the dispenser out. Easy .. popped new dispenser in and lightly put all six screws back in ,wired it back up after checking my photo. Closed the door ,slid front panel back on opened the door put the 4 screws back in that hold the front panel .Turned power back on and Boom!! All done.. Not bad for a girl...
6 of 7 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Customer:
Les from PASADENA, CA
Parts Used:
154859401
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins
Bottom door gasket leak
No tools needed. Pull out old gasket. Clean the track. Ensure snug fit all across the track, use your thumb to push new gasket into the track firmly.
5 of 5 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Customer:
Stephanie from Fort Wayne, IN
Parts Used:
5304507354
Difficulty Level:
Easy
Total Repair Time:
15 - 30 mins
Tools:
Screw drivers
Dispenser door latch broke
removed the screws holding the door together, then removed the screws holding the dispenser to the interior door. replaced the wires and put the door back together
5 of 6 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Customer:
Mary Pat from CAVE CREEK, AZ
Parts Used:
5304535382
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins
Bottom of Silverware gone,silverwear went to bottom of dishwasher
Your service was great, the basket came in two parts and all I had to do was put the two together and put it in the dishwasher. I am glad we were able to get a new one. Thanks again for such quick service. Thank you very much for such great service.
4 of 5 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Customer:
Keith from AURORA, IL
Parts Used:
5304534829, 5304506535, 154740304, 154428403
Difficulty Level:
Very Easy
Total Repair Time:
Less than 15 mins
Some rack components were rusted and broken. Replacement was necessary.
Repair was easily performed by removing old parts and snapping new ones into place.
I woulsugest that you take a picture before removing the old parts so that you can correctly orient the new ones.
4 of 5 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
All Instructions for the EIDW5905JS0A
1 - 15 of 44