D55152 (Type 2) DeWALT Compressor

This is an authentic manufacturer approved replacement part used on Dewalt air compressors. Its purpose is to filter out dust and debris from contaminating the engine. This filter is made out of foam ...

This cold start valve, also referred to as an unloader valve, is supplied by the original manufacturer for use in electric air compressors. It has a length of 0.63 inches, a 1/8-inch male pipe thread,...

This is an authentic DeWalt replacement part that has been OEM sourced to ensure a high-level of quality. This item is intended to be used with gas-powered air compressors. The manifold is one of the ...

This valve blade helps to control the fuel-air mixture admitted to the cylinder. As the piston rises in the cylinder a vacuum is created in the crankcase beneath the piston. Eventually the blade may w...

This is a genuine manufacturer-approved oil which is specially made for use with DeWALT air compressors. The oil allows internal components to move with minimal friction, please make sure to refer to ...

This is an authentic replacement part manufactured for use with DeWalt air compressors. The check valve is used to allow air to flow from the pump to the tank and prevents air from escaping the tank a...

It is an authentic manufacturer-sourced replacement gasket which is specially designed for use with DeWALT air compressors. This carburetor gasket provides an air-tight seal for the cylinder, over tim...

An authentic manufacturer-sourced replacement part that is specially designed for use with DeWALT compressors. This is the special gasket that helps to create an air-tight seal between the casing and ...

This is an OEM part sourced directly from the manufacturer. The screw is designed for use in DeWALT compressors. This part is made of metal, and is generally used in securing the crankcase cover. P...

This is an OEM part sourced directly from the manufacturer. The screw is commonly found in DeWALT compressors. This part is made of metal, and is generally used to secure the cover onto the crankcas...