AD50J2 Whirlpool Dehumidifier - Instructions
Jump to:
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
- Customer:
- Greg from Suches, GA
- Parts Used:
- 1168777
- Difficulty Level:
- Really Easy
- Total Repair Time:
- 15 - 30 mins
- Tools:
- Screw drivers
Evaporator freeze up
Troubleshoot on the schematic/wiring diagram to find the defective thermostat. Order a replacement part. Remove all outer covers to gain access to the thermostat. Only tool needed for this is a #2 phillips screwdriver. Cut the leads on the defective part and remove thermostat and replace thermostat, wire cutters/crimper required, splice the thermostat leads, Reassemble the outer covers.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Steven from Owings Mills, MD
- Parts Used:
- WP1172075
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
the dehumidifier was not shutting off when water level was full
replaced a piece of the plastic at the top of the bucket that seems to be the water gauge. this seems to be fixed. we are very happy
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- barbra from STERLING HTS, MI
- Parts Used:
- WP1172075
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
- Tools:
- Screw drivers
float was missing
pried off the plastic fastener with flat blade screw driver set new float in place then pressed plastic fastener back in place
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Lester from Brazil, IN
- Parts Used:
- 1188814
- Difficulty Level:
- A Bit Difficult
- Total Repair Time:
- 30 - 60 mins
- Tools:
- Screw drivers
Push on connectors and switch housing were different
The switch housing was not exactly the same for easy snap in. I removed the actual switch and installed it into the old housing. Then I found that the male pins were larger than the old ones. I chose to clip off the female connectores, strip the wires, and solder the wires to the pins on the switch. It was easier for me than attempting to change the push on connectors. For me, the actual switch was what I wanted and I fixed it my way. It was easy to do however some folks may want to change the push on connectors. Works great and saved me hundreds of dollars. Thanks.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- BRENT from MADISON, WI
- Parts Used:
- 4389130
- Difficulty Level:
- Easy
- Total Repair Time:
- 30 - 60 mins
- Tools:
- Nutdriver, Screw drivers, Socket set
original fan frozen so no rotation
instructions accompanying this replacement fan were great. Easily understood, correct, and instructive pics.
Was this instruction helpful to you?
Thank you for voting!