Models
>
LD651EBL
LD651EBL (ABKAHDP) LG Dehumidifier
Jump to:
Find Part by Name
Keep searches simple, eg. "belt" or "pump".
Diagrams for LD651EBL
Viewing 1 of 1
Keep searches simple, eg. "belt" or "pump".
In Stock
In Stock
Special Order
In Stock
Special Order
Questions and Answers
We're sorry, but our Q&A experts are temporarily unavailable.
Please check back later if you still haven't found the answer you need.
Common Problems and Symptoms for LD651EBL
Viewing 2 of 2Unit says bucket is full when it isn’t
Fixed by these parts
How to fix it
Won’t stay on
Fixed by these parts
How to fix it
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
- Customer:
- Seif from DETROIT, MI
- Parts Used:
- 6877A30013V
- Difficulty Level:
- Easy
- Total Repair Time:
- 30 - 60 mins
- Tools:
- Pliers, Screw drivers
bucket full light constantly blinking with error code 01 on the display
Unscrew and detached front and back panels, and inside framework holding the sheet metal to the body, after removing the sheet metal, unscrew the box enclosing the control board, use needle nose pliers to unhook the sensor module from the board and place the new sensor into the spots where the old sensor was connected (thermostat area, hu
... Read more
midity Sensor, bucket switch, and control board). Close up the unit and your good to go.
Read less
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- MICHAEL from LEBANON, PA
- Parts Used:
- MHA62753001
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
- Tools:
- Pliers
broken roller wheels
released broken wheels from their position using a screwdriver and secured new ones w/ a pliers.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Larry from North Ridgeville, OH
- Parts Used:
- 6877A30013V
- Difficulty Level:
- Easy
- Total Repair Time:
- 15 - 30 mins
- Tools:
- Pliers, Screw drivers
bucket full light was blinking and dehumidifier would run for a few seconds then turn off
remove outer shell and control panel. take cover off off electrical connection box. remove old sensor from front of condensing coil along with wiring harness to temperature sensor and bucket switch and circuit board. reinstall new sensor in the reverse procedure. reinstall covers.
Was this instruction helpful to you?
Thank you for voting!