919-72427 (Type 0) Craftsman - Instructions
Jump to:
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
- Customer:
- Charles from GARRISON, TX
- Parts Used:
- K-0650
- Difficulty Level:
- Easy
- Total Repair Time:
- 30 - 60 mins
- Tools:
- Screw drivers, Socket set
The air was bypassing the compressor gaskets and cylinder wall was worn out
1 remove cover
2 unhook air line to tank
3 remove head bolts
4 remove intake from head
5 remove flywheel bolt to free up pump piston
6 remove screw on top of piston to change out gasket
7 remove the cylinder sleeve install piston from the top
8 reassemble piston rod end and the flywheel
9 on the head cover are two gaskets one on top and one on the bottom head
10 insert intake piece and bolt the head cover back in place
11 reinstall the air line and unit cover and secure with three cover screws
2 unhook air line to tank
3 remove head bolts
4 remove intake from head
5 remove flywheel bolt to free up pump piston
6 remove screw on top of piston to change out gasket
7 remove the cylinder sleeve install piston from the top
8 reassemble piston rod end and the flywheel
9 on the head cover are two gaskets one on top and one on the bottom head
10 insert intake piece and bolt the head cover back in place
11 reinstall the air line and unit cover and secure with three cover screws
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Tim from Tucson, AZ
- Parts Used:
- ACG-408
- Difficulty Level:
- Very Easy
- Total Repair Time:
- 15 - 30 mins
Can't find this special screw used on many housings etc
Actually don't like using Torx bits because they are hard to center deep in the channel. I had misplaced these forcing me to order replacements.
My plan is to insert Torx bits before screwing in and using jb weld to secure the bit to the screw, giving me a hex head. Can't find this special screw with a hex head. This screw is called AGC-408 by craftsman.
My plan is to insert Torx bits before screwing in and using jb weld to secure the bit to the screw, giving me a hex head. Can't find this special screw with a hex head. This screw is called AGC-408 by craftsman.
Was this instruction helpful to you?
Thank you for voting!