Models > 580646621

580646621 (020322-1) Craftsman Pressure Washer

Jump to:

Find Part by Name

Keep searches simple, eg. "belt" or "pump".
Keep searches simple, eg. "belt" or "pump".
Garden Hose Filter – Part Number: B2384GS
$6.69
This is a genuine OEM sourced replacement part that is intended to be used with pressure washers from Craftsman. The screen fits into the water inlet tube and is used to prevent debris from the hose f...
On Order
Hose – Part Number: 189971GS
No Longer Available
Kit – Part Number: 200278GS
Kit
No Longer Available
Kit, Handle Fastening – Part Number: B2203GS
$8.25
This is a genuine item that is supplied directly from the original equipment manufacturer for use with Troy-Bilt and Briggs and Stratton pressure washers. It is an identical replacement for a missing ...
In Stock
Order now and your part arrives by Jun 4
Kit, Chemical Injection – Part Number: 200279GS
$35.30
This is available as a kit that contains all the necessary parts. These are OEM Briggs & Stratton and Troy-Bilt parts directly sourced from the manufacturer for use in pressure washers. They are made ...
In Stock
Order now and your part arrives by Jun 4
HOSE, 1/4 X 25 FT, M2 – Part Number: 196006GS
$31.40
This is an authentic OEM replacement part sourced directly from Craftsman. The water travels through this hose from the pump to the sprayer wand. Over time the hose may become clogged or damaged. This...
Special Order
Orifice – Part Number: B1236DGS
$30.13
In Stock
Order now and your part arrives by Jun 4
KEY, 3/16 SQ X 1 – Part Number: 23139GS
$2.99
Special Order
Kit, Vibration Mount – Part Number: 198766GS
$20.26
Special Order
Kit, Pump/engine Mounting Hard – Part Number: 192525GS
$17.83
In Stock
Order now and your part arrives by Jun 4
Goggles-Safety – Part Number: 87815GS
$19.16
Special Order
Assy, Pump – Part Number: 206383GS
Part 706385 Front Facing Pump and 706384 Rear Facing Pump Kits are the replacement for this pump.
No Longer Available
View More

Questions and Answers

Be the first to ask our experts a question about this part!

Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
Customer:
Anthony from RIDGEFIELD, CT
Parts Used:
189971GS
Difficulty Level:
Very Easy
Total Repair Time:
Less than 15 mins
Supplied hose has "press on" fitting on one end, washer does not accommodate it
One can either pull off the plastic fitting on one end (the one with an o-ring) and press the plastic tubing onto the pressure washer detergent inlet (located just behind the high pressure hose outlet/connector). The other end of the device is then inserted into a jug of pressure washer detergent and the lowest pressure nozzle or nozzle setting selected to allow detergent to be drawn up into the washwater stream with the pressure washer running. One can observe the detergent flowing into the washer if all is good! If one cannot pull off the plastic fitting on one end (the other fitting, to be left!, has a "screen" on its end - the fitting can be cut off the plastic tubing with a utility knife.
Read less
2 of 6 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
View More