Models
>
TGC3X4XCD1
TGC3X4XCD1 Tappan Cooktop
Jump to:
Find Part by Name
Keep searches simple, eg. "belt" or "pump".
Diagrams for TGC3X4XCD1
Viewing 4 of 4
Keep searches simple, eg. "belt" or "pump".
In Stock
This is now a new zinc and black-coated screw that will resist rust and
seizing.
In Stock
$94.23
This part sends enough current to the igniter to create a spark to the bottom of the burner cap.
Special Order
This part also includes 3 screws. Small burner cap is sold separately.
No Longer Available
When the gas burner valve knob is depressed and turned, this part creates a spark that lights the gas and starts the burner.
No Longer Available
Special Order
Special Order
$250.47
***No Conversion Kit Required - Adjust On Appliance***
This valve automatically cuts off the flow of a liquid or gas when it reaches a certain pressure.
On Order
Questions and Answers
We're sorry, but our Q&A experts are temporarily unavailable.
Please check back later if you still haven't found the answer you need.
Common Problems and Symptoms for TGC3X4XCD1
Viewing 3 of 3Will Not Start
Fixed by these parts
How to fix it
Gas igniter glows, but will not light
Fixed by these parts
How to fix it
Element will not heat
Fixed by these parts
How to fix it
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
- Customer:
- Rusty from Howell, NJ
- Parts Used:
- 316011200
- Difficulty Level:
- Easy
- Total Repair Time:
- 15 - 30 mins
- Tools:
- Screw drivers
Igniter porcelain was cracked and burner would not light.
un-pluged stove,removed the one screw holding the broken igniter. disconected the one wire. installed new igniter and slipped on wire. The igniter came with a new bracket, the old one rusted away which is why the old igniter broke.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- chris from Venice, CA
- Parts Used:
- 316011200
- Difficulty Level:
- A Bit Difficult
- Total Repair Time:
- 1- 2 hours
- Tools:
- Nutdriver, Pliers, Screw drivers, Wrench set
Bad igniter.
The stove was older so the burner was hard to get out. The small screw heads broke off, so I had to carefully center punch and drill out the screw bodies. The igniter screw was also frozen in the pot metal burner. That screw requied drilling and tapping with the installation of a new 6-32 screw. Once the burner was refurbished, the igni
... Read more
ter mounted easily. Afte attaching the gas line and igniter wire, the burner worked great.
Read less
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Terry from Wilkinson, IN
- Parts Used:
- 316011200
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
- Tools:
- Screw drivers
burner would not lite
no need to remover burner. Lift top up use a 1x4x5" to hold top up. Use short #2 screw driver remove screw and replace with new igniter
Was this instruction helpful to you?
Thank you for voting!