Models > TGC3X4XCC2

TGC3X4XCC2 Tappan Cooktop

Jump to:

Find Part by Name

Keep searches simple, eg. "belt" or "pump".

Diagrams for TGC3X4XCC2

Viewing 4 of 4
Keep searches simple, eg. "belt" or "pump".
This part is the replacement porcelain drip pan for your range or cooktop. It is a square-shaped drip pan and is black in color. It is approximately 9 inches in length and 9 inches in width. The drip ...
No Longer Available
Use this igniter with sealed burners.
In Stock
This is now a new zinc and black-coated screw that will resist rust and seizing.
In Stock
This part sends enough current to the igniter to create a spark to the bottom of the burner cap.
Special Order
This part also includes 3 screws. Small burner cap is sold separately.
No Longer Available
When the gas burner valve knob is depressed and turned, this part creates a spark that lights the gas and starts the burner.
No Longer Available
$43.44
Special Order
Sold Individually.
No Longer Available
No Longer Available
***No Conversion Kit Required - Adjust On Appliance*** This valve automatically cuts off the flow of a liquid or gas when it reaches a certain pressure.
In Stock
No Longer Available
$9.38
Special Order

Questions and Answers

We're sorry, but our Q&A experts are temporarily unavailable.
Please check back later if you still haven't found the answer you need.

Common Problems and Symptoms for TGC3X4XCC2

Viewing 3 of 3
Will Not Start
Fixed by these parts
Fixing Fixing
How to fix it
Gas igniter glows, but will not light
Fixed by these parts
Fixing Fixing
How to fix it
Element will not heat
Fixed by these parts
Fixing
How to fix it
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
Customer:
Rusty from Howell, NJ
Parts Used:
316011200
Difficulty Level:
Easy
Total Repair Time:
15 - 30 mins
Tools:
Screw drivers
Igniter porcelain was cracked and burner would not light.
un-pluged stove,removed the one screw holding the broken igniter. disconected the one wire. installed new igniter and slipped on wire. The igniter came with a new bracket, the old one rusted away which is why the old igniter broke.
53 of 76 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Customer:
chris from Venice, CA
Parts Used:
316011200
Difficulty Level:
A Bit Difficult
Total Repair Time:
1- 2 hours
Tools:
Nutdriver, Pliers, Screw drivers, Wrench set
Bad igniter.
The stove was older so the burner was hard to get out. The small screw heads broke off, so I had to carefully center punch and drill out the screw bodies. The igniter screw was also frozen in the pot metal burner. That screw requied drilling and tapping with the installation of a new 6-32 screw. Once the burner was refurbished, the igni ter mounted easily. Afte attaching the gas line and igniter wire, the burner worked great.
16 of 18 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Customer:
Terry from Wilkinson, IN
Parts Used:
316011200
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins
Tools:
Screw drivers
burner would not lite
no need to remover burner. Lift top up use a 1x4x5" to hold top up. Use short #2 screw driver remove screw and replace with new igniter
12 of 16 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!