MGC4430BDW11 Maytag Cooktop - Instructions
Jump to:
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
- Customer:
- Anna from MONROVIA, CA
- Parts Used:
- WP7733P382-60
- Difficulty Level:
- Very Easy
- Total Repair Time:
- Less than 15 mins
My cooktop knob melted
I had used a pan too large for the middle burner - result: melted knob. Just pulled the old one off (up and straight) and then pushed the new one down firmly. Make sure the indicator line is pointing at you, so the flat side of the spindle matched the flat side of the hole on the knob. Easy peasy.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Carolyn from St. George, UT
- Parts Used:
- WP7518P465-60
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
black dirty burner grates
replaced grates
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Thomas from ROGERSVILLE, TN
- Parts Used:
- WP7733P381-60
- Difficulty Level:
- Really Easy
- Total Repair Time:
- 30 - 60 mins
One control knob got partially melted by a hot pan touching it.
I never did receive the part. It was a knob. Part numberPS11744700. Must've got lost in the mail. Thanks. Thomas Horne, 266 Eedmont Ct., Rogersville,Tn 37857?............P.S. The cost of it cleared my bank.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Raymond from Allen, TX
- Parts Used:
- WP3801F935-51, WP7101P062-60
- Difficulty Level:
- Really Easy
- Total Repair Time:
- 15 - 30 mins
- Tools:
- Screw drivers
new countertops required remounting the gas cooktop
A very simple repair.
I inserted the brackets and screwed them in position
I inserted the brackets and screwed them in position
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Jerald from Loveland, OH
- Parts Used:
- W11170853
- Difficulty Level:
- Easy
- Total Repair Time:
- 1- 2 hours
- Tools:
- Wrench (Adjustable), Wrench set
Missing regulator when floor model gas cooktop was purchased
1. Apply gas pipe joint sealer to treaded nipple on bottom of cooktop; 2. Install regulator on nipple with regulator direction arrow pointing to top of cooktop; 3. Tighten but do not overtighten as it may crack the aluminum body regulator; 4. Make sure the face of the regulator with the green painted surface faces the outside of the cabinet; 5. Get a new gas flex hose to connect to gas pipe (got mine at Lowe's - 2 feet long with all the right fittings for about $15). 6. Follow instructions on gas flex hose - make sure you use gas pipe joint sealer only where indicated; 7. Turn gas shutoff valve back on and test for leaks using soapy water; 8. Turn on each cooktop burner to bleed out air.
Was this instruction helpful to you?
Thank you for voting!